Kosan Crisplant Missouri, Inc.

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee was operating an aerial work platform. While the employee was maneuvering the lift through a set of double doors, their head was caught between the door frame and the platform's vertical mast. The employee suffered a skull fracture that required surgery.

An employee was transporting used filter media (containing pyrophoric iron sulfide) from an inlet gas separator in the bed of a truck. The material ignited. While the employee was removing items from the truck bed, a gas can was exposed to the fire and off-gassing vapors ignited. The employee suffered first- and second-degree burns to both arms, the chest, the neck, and the right ear. The employee was hospitalized.

An employee was using a pipe threading machine to thread a 2-inch diameter gas pipe during the rebuilding of a gas meter. The pipe was in a vise mounted on the back of the crew truck. A few pieces of metal chips or shavings caused the threading machine to jam. The employee started to back the pipe up, but it jammed in that direction as well. While reaching to pull the handle back up into place to try and start again, the machine rotated about an inch and pinched his middle fingertip against the edge of the truck s back step. The employee's fingertip was partially amputated without loss of bone.

The injured employee was manually lowering a ramp on a heavy equipment trailer with the assistance of another employee. The injured employee was standing behind the trailer ramp. After removing the safety pins, the ramp descended quickly and struck the injured employee, causing them to fall to the ground. The employee was hospitalized with fractures to their sternum and L1 vertebra.

An employee was lighting a tankless water heater when an explosion occurred and the employee was burned.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.