Gardner Denver Thomas, Inc.

An employee was repositioning a spherical piece of stock metal in a press when the press came down on her index finger, amputating it at the knuckle.

An employee was changing a saw blade when the saw machine activated. The employee's left ring and little fingers were amputated.

An employee was clearing a jam from the label cutting machine when their left middle finger was partially amputated.

Two employees were repairing the hydraulic engagement pins on a rented front-end wheel loader. The machine controls were activated to move the attachment pins and an employee's finger was caught between the pins and the bushings. Their right index finger was partially amputated.

An employee was cleaning the conveyor on a piece of equipment when they slipped and their right hand was pulled into the chain sprocket. The employee's fifth fingertip was amputated.

An employee was throwing blankets onto a blanket folding and stacking machine. A blanket got stuck in the machine and she attempted to remove it when the machine contacted her right little finger, resulting in a fingertip amputation.

An employee was spotting a crane when the load (fabricated skid for packaged equipment) that was being picked up came loose and fell on the employee. The employee sustained a crush injury resulting in a fractured pelvis.

An employee was setting up dies on a die casting machine. The machine's ram unexpectedly returned from the down position and caught the tip of the employee's right thumb against a pinch point in the shot sleeve. The employee suffered an open fracture/amputation to the thumb tip. The machine was not locked out at the time.

Employee 1 was cleaning a paint gun using paint thinner when employee 2 started a lighter nearby and the cup of paint thinner ignited. Employee 2 dropped the cup and the ignited paint thinner spilled, causing burns on employee 2's arms, legs, hands, and face.

An employee was installing a part using an aerial lift and a ratchet. The lift rose and crushed his left thumb.

An employee was servicing a reciprocating air compressor when their left middle finger was caught in a belt motor pulley sheave while manually moving the belt. Approximately 1/4 inch of the employee's left middle fingertip was amputated.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.