Nonroadway incident involving motorized land vehicle, unspecified · Crushing injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Revere Copper Products, Inc., 1 Revere Park, ROME, NEW YORK 13440
on — Crushing injuries, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was unloading a truck with a forklift. The employee's right hand was caught between the forklift's roll cage and a computer keyboard's metal swing arm. The little finger was crushed at the knuckle and the ring finger was lacerated.
HospitalizedFinger(s), fingernail(s), n.e.c.Forklift, order picker, platform truck-powered
More severe injuries at Revere Copper Products, Inc.
An employee was setting up a furnace and lighting the torch on the furnace when they sustained burns from a flashback flame. The employee was hospitalized with burns to their head, face, chest, arms, and armpit area.
An employee was moving a loaded lift from an aisle when it became wedged in the aisle and abruptly stopped, throwing the employee. The employee suffered a concussion, and fractures to two neck vertebrae and the left scapula.
An employee was in the basket of an aerial lift while unloading it from a flatbed trailer. The brake released, causing the aerial lift to strike another lift. The employee sustained a partially collapsed lung, rib fractures, and bleeding from the kidneys.
An employee was moving materials using an all-terrain vehicle when the vehicle struck an overhead boom. The employee's head struck against the steering wheel and he was ejected to the concrete ground. The employee was hospitalized with a head injury.
An employee was loading and unloading palletized material with a powered pallet jack. The pallet jack backed up and the employee's leg was crushed between the pallet jack and a bumper/trailer hitch, resulting in fractures to the right ankle and left tibia.
An employee was operating a forklift and went to grab a hold of the swinging arm to swing it into place. His hand was caught between the forklift and the swing arm, resulting in a middle finger amputation.
More severe injuries in this industry (NAICS 331421)
An employee was polishing a bar on the lathe with sandpaper when the bar wrapped around the employee's glove and pulled it off. The employee sustained fractures to their index finger, wrist, and a knuckle.
An employee was using an electrical meter to troubleshoot an electrical drive system. While removing the probe, the employee made contact with the bus and was shocked. The employee sustained burns to their fingers and a dislocated shoulder.
An employee was setting up a furnace and lighting the torch on the furnace when they sustained burns from a flashback flame. The employee was hospitalized with burns to their head, face, chest, arms, and armpit area.
An employee was using a metal bar tied to a nylon strap attached to a jib crane to tighten a metal ring on a heated extrusion press. The metal bar flew off and struck the employee in the left forearm, fracturing it.
An employee was troubleshooting the lift table of the automated take-up mechanism on the jacket extrusion line. He was able to get the table to raise up, at which point it engaged and lowered. The employee's leg was pinned between the lift table and the concrete floor. His ankle was broken and he was hospitalized, requiring surgery.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.