Contact with objects and equipment, unspecified · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at Revere Control Systems Inc., 2240 Rocky Ridge Road, BIRMINGHAM, ALABAMA 35216
on — Soreness, pain, hurt-nonspecified injury, affecting the eye(s).
Watch Revere Control Systems Inc. — freeGet an email when a new federal OSHA severe-injury report for Revere Control Systems Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee opened the door of an enclosure and, while looking at a termination, was struck in the right eye by a disconnect panel shaft. The eye was injured.
Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.
Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.
An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.
More severe injuries in this industry (NAICS 333922)
An installation technician for a wind turbine lift was using a chain hoist to move materials up a tower. The chain storage unit overflowed; the chain spilled and fell about 40-50 feet down the tower. It struck the injured employee in the face, causing fractures to their nose and cheekbones.
On November 25, 2024, at 9:00 a.m., two employees were moving a metal staging pallet that was located in an automation cell. The injured employee slipped and their left middle finger was crushed between the pallet and metal frame of the machine, resulting in an amputation to the finger padding.
On October 22, 2024, at approximately 10:15 a.m., an employee was forming a stand leg on a standard brake press. As they were readjusting the part, the tip of their right thumb was caught in the brake press, resulting in a partial amputation. The incident occurred during training.
An employee was cleaning welding debris from a steel part that was in a fixture. The part moved, cut through the employee's cut-resistant glove, and amputated their right middle fingertip.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.