Progress Rail (Alliance)

An employee was using a pancake huck tool to remove hucks from a column guide wear plate on a side frame when the hose on the pressure side of the tool burst where he was holding onto it, injecting oil through his glove and into his left hand.

An employee was unloading a trailer when a box fell and struck the employee in the face. The employee suffered a concussion and was hospitalized.

An employee had been cutting lumber for a shed wall. A load of 16-foot trim pieces fell onto the employee causing vertebrae and ankle fractures.

An employee was unloading 30-foot 2-inch barrels from a pan holding about 20 barrels. The barrels tipped over, striking and breaking both of the employee's lower legs.

An employee was in a sandblasting area, preparing the surface of a plate heat exchanger frame for painting. The frame fell on the employee, who suffered fractures to vertebrae, the neck, pelvis, and rib cage; and punctured lungs.

An employee was installing doors when one of the doors fell on him, fracturing his lower leg. The employee was hospitalized.

An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.

An employee was sampling a railcar in a storage yard. After sampling the railcar, the employee was climbing down the railcar ladder when he fell off the top step of the ladder to the ground, resulting in fractures to six ribs, his right arm, and two vertebrae.

Employees were watering a train at a train platform. One of them went to step over a hose, tripped, and fell to the ground. He suffered a broken knee. The employee was hospitalized for surgery.

Employees were performing maintenance operations on a railroad line when the machine experienced a load conveyor motor failure. While clearing the machine to allow for repairs, an employee pinned the left side of the swing conveyor. The operator on the right side then requested a slight bump to the left to align the right side for pinning. Once the swing was in position, the operator went to pin the right side and the chain tensioner failed, resulting in an abrupt release of the swing chain. The chain snapped back and struck the operator s right hand, resulting in a 1-inch laceration and a fractured fifth metacarpal. The employee was hospitalized and required surgery on the hand.

The injured employee loaded a container onto a railcar and then mounted the railcar to put in the locking mechanism for the container. The employee was struck by another container that a crane was loading onto the railcar and fell approximately four feet from the railcar to the concrete ground. The employee sustained fractures to their pelvis, shoulder, and two ribs.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.