Machinery or equipment incident on water vehicle · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Ervin Cable Construction, LLC, Greenleaf Creek, BRAGGS, OKLAHOMA 74423
on — Amputations, affecting the fingertip(s).
Final narrative
Two employees were troubleshooting a pontoon boat motor. The motor began to run and the flywheel of its engine contacted an employee's right middle finger. The employee's fingertip was amputated.
AmputationFingertip(s)Water vehicle, unspecified
More severe injuries at Ervin Cable Construction, LLC
An employee was working in a bucket truck to put up a cable for a new telecommunication line on a utility pole. The employee was trying to throw the line over the trees when the line got stuck in vegetation and the employee fell 20 feet from the bucket to the ground. The employee suffered a broken leg and back injuries and was hospitalized. Fall protection was not worn at the time of the incident.
An employee was placing fiber optic cable. A winch rope gained tension and one of the bull snaps failed, lacerating the employee's left palm and fracturing the employee's left little finger.
Employees were unloading logs on a logging vessel. The injured employee was standing on the deck as a load came in. The sling popped off the load and the end of the choker struck the employee's lower left leg, resulting in a shin fracture.
An employee was exiting a confined space while carrying a pressure gun when the trigger activated. Water penetrated the employee's left arm, resulting in injury.
The employee was putting shackles on the grab of a vessel-operated crane. As the crane was lifting the grab, it started to swing toward the hopper. The employee reached to stop it when they were caught and lifted by the grab and pinned between it and the hopper. The employee sustained a pelvic fracture and lacerations to the arm and pelvis.
An employee was launching a boat during rough sea conditions. The employee lost balance, causing their left index and middle fingertips to be caught in the eye of the bow line, resulting in amputation.
Two employees were in a boat pulling a 45-pound anchor out of the water by the rope. The rope tightened and as the employees were attempting to create slack in the rope, the injured employee began to slip. His hand was caught between the rope and the inside of the platform boat, resulting in amputation of the right middle finger with bone loss.
More severe injuries in this industry (NAICS 237130)
An employee was terminating cables in a junction box. A loose ground wire came into contact with the bushing, causing a flash that burned the right side of the employee's face and his right hand.
An employee was using a bucket truck hoist to raise secondary aerial wiring. The wire made contact with the primary wire, causing an arc flash. The employee suffered burns to both hands and was hospitalized.
An employee was terminating conductors to buss bars inside the secondary compartment of a single-phase transformer. An arc flash occurred, causing burns to the soft tissue of the employee's face.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.