Trip over an object without fall · Dislocation of joints
At a glance
Federal OSHA recorded a severe workplace injury
at Robinson Glass, Inc., Oral Roberts University Mabee Center, TULSA, OKLAHOMA 74171
on — Dislocation of joints, affecting the knee(s).
Final narrative
Employees were at a site to remove old glass from a building and install new glass when it began to rain. An employee was stowing a lift when he stumbled over a curb/curb bumper and dislocated his knee.
HospitalizedKnee(s)Bodily motion or position of injured, ill worker
An employee was using a large pot to carry hot oil from the fryers. His left foot got caught on a hose that was on the floor and the pot fell. When the pot hit the floor, the hot oil splashed upward onto the employee's face, hands, and legs causing second-degree burns.
An employee was walking from their work station when he stepped on a wooden board and rolled his ankle. He sustained a pelvic injury that required surgery.
While on a scissor lift, an employee was cleaning an overhead fan. The employee tripped over the hose of a wet/dry vacuum and his right hand struck the running fan blade resulting in amputation of the middle fingertip. The fan was not guarded at the time of the incident.
At 3:23 p.m. on March 21, 2022, an employee was returning to her workstation when she tripped over a plastic band with her left foot, suffered a broken right femur as she tried to regain her balance, and collapsed to the floor. She was hospitalized.
An employee was climbing down a track ladder. The employee's left foot twisted on a step as their other foot reached the floor, and the employee's shin was broken.
More severe injuries in this industry (NAICS 444190)
An employee was unloading freight from a truck when a stack of doors fell over and knocked the employee to the ground. The employee sustained a fractured femur.
An employee was performing rebar fabrication using a bending machine. The employee's glove became caught in the area where the rebar bend overlaps onto itself. The subsequent bending/cutting caused the two overlapping portions to squeeze together and amputate approximately 1/4" of his left index fingertip.
An employee was building wood detail blocking and a wood member needed to be resized. The employee took the wood member to the table saw and set the fence to the correct size. The employee pressed down on the board to control it when his left little finger contacted the running blade, resulting in an amputation.
An employee was clearing a pipe along a culvert using a motorized plumbing machine. The end of the machine got tangled and stuck in long grass and other debris. The employee went to lift the end of the machine out of the grass and clear the blockage when his hand was pulled into the machine, resulting in a partial amputation and open fracture of his left distal phalanx.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.