BAE Systems Norfolk Ship Repair

An employee was rigging when their left little finger became caught between a bearing and a shaft flange resulting in amputation.

An employee was operating a magnetic-mounted drill to drill one-inch holes in a stainless steel I-beam. As the employee was using a fox-tail style brush to sweep metal shavings off the I-beam his right middle finger was caught in the rotating drill bit. His right middle finger was degloved and two other fingers were fractured. He also sustained a fractured wrist. The employee was hospitalized.

An employee had been sand blasting and removed a valve pipe plug when it became clogged. As the employee was removing material, air bled out of the system and caused the valve piston to shut and amputate the employee's left index fingertip.

On 11/22/2023, at 8:35 AM, an employee was stepping onto a barge when they slipped on a wet surface and fell on their knee. The employee sustained a torn ligament in their knee requiring hospitalization and surgery.

After moving a barge lid, an employee was walking down the stairs on the barge when they slipped and fell approximately 15 to 20 feet, reuslting in a head injury.

An employee was using an excavator on a barge to scoop and remove fertilizer product stored in the cargo area. As the employee was transporting the skid-steer by chains and hoisting equipment from the dock to the barge, the employee fell approximately 10 feet off the skid-steer bucket to the cargo hold area below. The employee suffered a concussion.

Swingmen were performing discharge of an iron ore vessel. The discharge process consists of gathering remaining product into the center of the hold to facilitate removal by crane. At approximately 11:45 PM, a swingman was descending a ladder into a hold when he lost his footing and fell approximately 10-15 feet to the deck of the hold. The employee sustained fractures to their back and left leg.

An employee was on a bulk carrier ship. While removing lashing from wind turbine components, the employee lost balance and fell approximately 6 - 7 feet from a hatch to the deck of the ship. The employee was hospitalized with a head injury, and a fractured wrist, and required surgery.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was struck by a plasma cutter and suffered a broken left tibia and fibula. The employee was hospitalized.

An employee was preparing to bend a flat bar in a brake press. When the machine was jogged, the stock rotated up and crushed his left middle fingertip against the outer frame of the die. The fingertip was amputated.

An employee was cutting metal with a torch. A piece of metal struck the employee's left foot, causing multiple fractures to metatarsal(s). The employee was hospitalized.

An employee was descending a ladder carrying a bag of trash. He fell, landed on the ground about 10 feet below, and suffered fractures to his right hip and pelvis.

A building engineer was inspecting a generator. As he closed the generator enclosure door, his right ring finger was caught between the door and the door frame. The fingertip was amputated.

An employee was walking back to a carrier case with mail in her hand when she tripped over a tub. Her back overarched as she fell, resulting in a fractured back that required hospitalization.

An employee was driving a utility tractor rig when it struck the rear trailer of another utility tractor rig, which was traveling in the opposite direction. The glancing impact caused damage to the cab, and he sustained a laceration on right side of his face, a cervical fracture, two fractured left ribs, and a pelvic fracture. The employee was hospitalized.

An employee was washing an aircraft from a scissor lift when they fell to the floor. The employee sustained a back injury and lacerations to their head and neck.

An employee was working with a drill and a metal cable. The drill caught the cable and caused an amputation to the employee's left ring finger.