Ignition of clothing from controlled heat source · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Southern Parallel Forest Products Corp., 660 Industrial Boulevard, ALBERTVILLE, ALABAMA 35950
on — Heat (thermal) burns, unspecified, affecting the upper and lower limb(s).
Final narrative
An employee was cleaning scanners with rubbing alcohol when he spilled the solution on his clothing. While taking a cigarette break, the flame from the lighter ignited the alcohol on the employee's clothing, causing his pants to catch on fire, resulting in burns to his left hand and left leg.
HospitalizedUpper and lower limb(s)Blouses, shirts, dresses, trousers, skirts
More severe injuries at Southern Parallel Forest Products Corp.
An employee was in the sawmill basement using a push broom and shovel to clean wood chips and sawdust. The employee's right arm was struck by a wooden board between the wrist and elbow, resulting in a fracture.
An employee was trying to move a tangled drive chain. The employee's left ring finger got caught in the drive chain when the motor started. The employee required surgery to remove the fingernail and close the wound.
A forklift was lifting a block cart so an employee could hit the caster wheel with a "dead sledge" in an attempt to straighten the wheel. Due to the striking of the caster wheel, the block cart shifted and slipped on the forks, which caused the base plate to slide off the block cart. The employee lost his balance and fell to the ground. The base plate slid and struck the employee's left leg causing a broken left femur.
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 321113)
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
An employee was traveling down the maintenance aisle of a warehouse on a single-pallet front rider jack. The jack malfunctioned, causing the brakes to apply; the employee fell forward onto the concrete warehouse floor. The employee suffered an injury to the left leg and was hospitalized, requiring surgery.
An employee was operating a metal roller machine to roll a small piece of metal. The employee's right index finger became caught between the metal and the machine, and the fingertip was amputated.
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.