Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at ITW Converted Products, 40 East Newberry Road, BLOOMFIELD, CONNECTICUT 06002
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was putting material into position for processing. The employee's hand was caught in the nip point of a rotating piece of equipment. At least one of the employee's fingers was amputated.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333519)
Three employees were engaged in horseplay when one employee suffered a laceration to the abdomen, caused by a pocket knife. The employee was hospitalized.
An employee was standing on a step ladder and operating a hydraulic jack. The jack began shifting, causing the ladder to tip to the left. The employee caught himself as he was stepping down from the third rung of the ladder. When he stepped to the floor, his left foot rolled and twisted under his body weight, resulting in fractures to his tibia and fibula above the ankle.
On August 1, 2024, an employee was working on a press and dumping scrap material from the center piece to a scrap barrel when their finger became caught in the hole of the center piece and was crushed between the center and the edge of the roller on the conveyor. The employee sustained an amputation of three-quarters of their finger.
An employee was removing grating to change metal chip hoppers located in a pit. The employee lost his balance and fell approximately 12 feet from the grate, landing in the metal chip hopper. The employee sustained a sprained right foot, a left foot fracture, and a fractured L5 vertebra.
An employee was using a hammer to hit a steel bearing and dislodge it from a shaft. A small piece of the bearing broke off and embedded in his stomach.
An employee was checking on a machine outside of the building and removed a cover to clean out a blocked area. His hand was caught by a rotary valve in a dust collection machine. The employee's fingertip was amputated.
An employee was working to clean a glue roller with a scraper tool. The tool and the employee's left thumb were pinched between two rollers, resulting in a partial amputation.
An employee was re-arranging boxes of pipe insulation on a pallet. One of the boxes fell from the pallet and knocked over an upright empty cylinder. The cylinder fell and crushed the tip of the employee's right toe. The employee's toe required surgical amputation.
An employee was securing the claw of a grapple truck to the truck bed. His left little finger was caught between the tie down strap and the rub rail of the truck, resulting in partial amputation of the finger.
An employee was cutting extruded aluminum framing material using a horizontal band saw. She went to grab a rag in the machine when the rag contacted the blade and pulled her hand in toward the blade, resulting in a partial amputation of the right index finger.