Struck by discharged or flying object, n.e.c. · Multiple traumatic injuries and disorders, n.e.c.
At a glance
Federal OSHA recorded a severe workplace injury
at Quality Tool, Inc., 301 SUNRISE RIDGE ROAD, BROOKINGS, SOUTH DAKOTA 57006
on — Multiple traumatic injuries and disorders, n.e.c., affecting the chest, except internal location of diseases or disorders.
Final narrative
An employee was operating a coil-fed hydraulic punch press when a strip of material jammed in the die. The employee removed the guide rails and cleared the jam. The employee then re-secured the guide rails to the bottom die set by tightening the bolts. The employee then cycled the press, and a 2-inch guide rail shot out of the die and embedded in the employee's right side directly below the chest cavity causing a laceration, blunt force trauma, and a bruised liver. The employee required hospitalization and surgery.
HospitalizedChest, except internal location of diseases or disordersMachine and appliance parts, n.e.c.
At 4:00 p.m. on July 3, 2023, a severe thunderstorm passed over a job site. An employee was taking shelter under a carport where batteries were stored. The carport was destroyed; flying objects struck the employee, who suffered a jaw injury and a knee injury.
An employee was clearing a clogged sugar chute, containing rare earth magnets inset into an aluminum bar to catch any metal in the sugar. The employee loosened the middle of three magnets and it was attracted to the outside magnet, crushing the tip of his right middle finger. The fingertip was amputated.
An employee was working in the pallet repair line when a pneumatic nail gun shot a nail into their right wrist. The employee was hospitalized and required surgery to remove the nail.
An employee was emptying a plastic bucket of soils around a newly planted tree using a hay hook to assist. The hay hook suddenly broke free of the plastic bucket and struck the employee in the right eye, resulting in blunt-force trauma injuries to their eye.
More severe injuries in this industry (NAICS 332710)
An employee was positioning dunnage on a trailer while pipe was unloaded from a forklift. A pipe fell and the employee's right thumb and index finger were caught between the pipe and a piece of dunnage. The thumb was crushed, and the index fingertip was amputated.
An employee was using a lifting sling on a crane to move a straight-bar bundle and place it on top of an existing bundle. When moving the lifting sling, it became pinched between the bundle and a wood cleat. The bundle then fell onto the employee's left foot, resulting in crush injuries.
An employee was stacking metal tubes using a forklift. A stack became unstable and the employee got out of the forklift to steady it, instructing his helper to get into the forklift. The forklift movement caused some tubes to fall and strike the employee, resulting in an open fracture of his left hand.
An employee was setting up a flexible gear coupling hub in a lathe, preparing to bore it out to fit a shaft. The hub assembly was not secured in the chuck when the crane support was removed, and the employee's right little finger was caught between the hub assembly and the inside of the lathe. The fingertip was amputated.
An employee was using a crowbar to loosen a flat bar when the crowbar struck the employee's right eye. The employee was hospitalized and required surgery.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.