Reinke Manufacturing Co., Inc.

An employee was operating and clearing a stiffener press when their finger was amputated.

An employee was trying to remove the rollers from the bottom of a lathe using a piece of channel iron and two small jacks. As the employee was jacking up the jacks, the channel iron fell off and struck the employee's right forearm, breaking his radius.

An employee was using a shepherd's hook to help position a jib crane. The hook slipped and the employee fell into an adjacent structure, suffering three broken ribs and a punctured lung.

An employee was taking measurements of a parapet cap when they fell to the ground sustaining fractures to a shoulder and arm.

An employee was cleaning a two-story house. They fell approximately 12 feet from the roof to the floor and sustained fractures to both wrists.

An employee was using a water hose to clean the outside of a wastewater drain system when he fell into an area of the drain that was not covered. Hot water and chemicals caused first, second, and third-degree burns all over the employee's body. The employee was hospitalized.

An employee was cutting down a steel above-ground storage tank. He was on the roof of the tank when he fell 20 feet to the ground, resulting in a broken elbow and sprained leg. The employee was wearing a harness that was tied off at the time.

An employee was welding lift arms when their shirt caught fire due to welding sparks or heat, resulting in thermal burns to their upper chest.

An employee was climbing up a fixed ladder alongside a building to inspect a roof leak. The employee fell off the ladder and landed on the ground about 15 feet below. The employee was hospitalized with fractures to both wrists.

On September 16, 2025, an employee went to pull a weld stand when he tripped and fell, landing on the floor on his right hip. The employee suffered hip and fibula fractures that required hospitalization and surgery.

An employee was accessing a tensioned hook that required a hoist mechanism to be engaged. He was unhooking the lift hook from a shelf column when the "up" button was pressed, which released the tension on the pneumatic air hoist. The employee's right index finger was caught between the hook and the column, resulting in a soft tissue amputation and fracture to the fingertip.

A crane was lifting a pole out of a zinc bath in the galvanizing department when the chain attached to the pole broke. The pole fell back into the bath and liquid zinc splashed onto an employee, who suffered third-degree burns to an arm, the abdomen, the torso, the upper left side of the chest, an ear, the neck, and a hand.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.