Building Erection Services Co.

An employee fell onto a safety rail and suffered broken ribs. He was wearing fall protection.

The injured employee was standing at the base of a ladder assisting another employee install a TV on a wall. The TV was dropped, striking the employee. They sustained a head injury.

An employee and a colleague were moving two pieces of rebar when a tie was cut. The employee holding the rebar dropped it while it was above the injured employee's hands, resulting in partial amputation to their left middle finger.

An employee was bracing an extension ladder while his coworker installed a 10-foot, 40-45-pound pipe. The pipe fell onto the injured employee's head and he sustained a hematoma, C3 and C4 vertebral fractures and a forehead laceration.

An employee was helping to lift a press roll in to fix an issue that was occurring. A co-worker lost their grip and the press roll fell onto the injured employee's left index finger, resulting in a crush injury and amputation.

Three employees were removing equipment from an old fermentation room at a bakery. They were using two bakery dollies to remove metal plates from the floor of the room. One of them was holding one of the metal dollies with his right hand on the side of the dolly, as a plate was being centered on the two dollies. The plate slipped and struck his right thumb, which was amputated near the last joint.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.

An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.

An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.

An employee was on a step ladder in a store aisle, making room on shelving for merchandise. She fell from the step ladder to the floor, suffering two fractures in her left leg. She was hospitalized, requiring surgery.

An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.

An employee lost his footing while climbing an inclined ladder. He stumbled down one step and was able to stabilize himself by holding the railing and twisting his body, but he suffered an internal abdominal injury and was hospitalized.

An employee was manipulating dies on a brake press. The press caught and crushed the employee's right forearm, resulting in hospitalization.