TriMark Strategic

The injured employee was standing at the base of a ladder assisting another employee install a TV on a wall. The TV was dropped, striking the employee. They sustained a head injury.

An employee and a colleague were moving two pieces of rebar when a tie was cut. The employee holding the rebar dropped it while it was above the injured employee's hands, resulting in partial amputation to their left middle finger.

An employee was bracing an extension ladder while his coworker installed a 10-foot, 40-45-pound pipe. The pipe fell onto the injured employee's head and he sustained a hematoma, C3 and C4 vertebral fractures and a forehead laceration.

An employee was helping to lift a press roll in to fix an issue that was occurring. A co-worker lost their grip and the press roll fell onto the injured employee's left index finger, resulting in a crush injury and amputation.

Three employees were removing equipment from an old fermentation room at a bakery. They were using two bakery dollies to remove metal plates from the floor of the room. One of them was holding one of the metal dollies with his right hand on the side of the dolly, as a plate was being centered on the two dollies. The plate slipped and struck his right thumb, which was amputated near the last joint.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.

An employee tripped while stepping over a hose, fell on the ground, and dislocated his shoulder. He was hospitalized.

An employee was assisting with cutting a vertical steel pile. A 16-foot by 9-inch section of pile dropped to the side and bounced off a previously cut pile and toward the employee. The employee was struck in the torso and leg, causing his knee to dislocate from his femur. The employee was hospitalized.

On July 30, 2025, an employee was utilizing a circular saw to cut plastic into strips that would be used as shims. The blade of the saw amputated his left little finger to the second knuckle.

An employee was working on the ingot loader of a aluminum processing machine and noticed a pin was not installed. The employee reached to retrieve the pin and the machine activated for a functions test. The machine closed on the employee's hand, resulting in a hand injury requiring hospitalization.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.