CCS Contractor Equipment & Supply, LLC dba Surebuilt

At about 2:00 p.m. on March 14, 2025, an employee was setting up a threader machine. When the machine was restarted, a 15-inch Allen wrench (which had been used to tighten the die and was still attached) whipped around and struck the employee's left forearm. His arm was broken and he was hospitalized, requiring surgery.

An employee was using a machine to thread rebar. The spinning bar amputated the employee's finger and thumb.

An employee was loading material into a shear cutting machine when they sustained an amputation to their right thumb.

Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.

An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.

An employee was being trained on a machine when a roller came down on their hand, resulting in a fracture and laceration.

An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.

An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.

An employee was shoveling excess material (spillage) that consisted of dry mix, sand, aggregate and cement. As he was shoveling, some material blew back in his face and around his safety glasses. He got a piece of metal in his left eye that required surgery. The employee was hospitalized.

An employee was spotting the dust auger as it was lowered onto the trailer so that it would not contact a piece of equipment already on the trailer and pinch electrical cords. As the auger was being moved into place horizontally, his thumb was caught between two brackets, one on the auger and one on a piece of equipment already on the trailer. The employee sustained a partial amputation to the left thumb.

A temporary employee was bending rebar on a bending table (machine) when his right little finger got caught in the rollers. The employee sustained an amputation down to the first knuckle below the fingernail.

At 10:00 a.m., an employee was preparing to cut lumber for an A-frame structure using a compound miter saw when the saw kicked back and contacted his left hand. The employee sustained complete amputation of the thumb and a partial amputation of the index finger.

An employee was unloading a bundle of quartz slabs from a truck bed using a forklift and lifting slings. The employee was standing on the truck bed to secure the slings to the bundle when one of the two A-frames supporting the bundle fell over. The employee jumped off the truck bed to avoid being hit, causing them to strike the ground and sustain fractures to their left hip, femur, and elbow.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.