Contact with objects and equipment, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Manitou Equipment America, LLC, 915 South West 7th Street, MADISON, SOUTH DAKOTA 57042
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee sustained an avulsion while separating steel parts from a steel skeleton sheet and sorting them. The employee underwent a medical amputation to the finger.
An employee was removing a small sheet metal part out of the die of the brake press. The foot pedal was pressed, causing the part to lift and crush their left thumb against the die. The employee suffered an amputation to the thumb tip including the loss of flesh and the fingernail.
Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.
Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.
An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.
More severe injuries in this industry (NAICS 333111)
An employee was climbing up a fixed ladder alongside a building to inspect a roof leak. The employee fell off the ladder and landed on the ground about 15 feet below. The employee was hospitalized with fractures to both wrists.
On September 16, 2025, an employee went to pull a weld stand when he tripped and fell, landing on the floor on his right hip. The employee suffered hip and fibula fractures that required hospitalization and surgery.
An employee was accessing a tensioned hook that required a hoist mechanism to be engaged. He was unhooking the lift hook from a shelf column when the "up" button was pressed, which released the tension on the pneumatic air hoist. The employee's right index finger was caught between the hook and the column, resulting in a soft tissue amputation and fracture to the fingertip.
A crane was lifting a pole out of a zinc bath in the galvanizing department when the chain attached to the pole broke. The pole fell back into the bath and liquid zinc splashed onto an employee, who suffered third-degree burns to an arm, the abdomen, the torso, the upper left side of the chest, an ear, the neck, and a hand.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.