American Construction Company

On 11/22/2023, at 8:35 AM, an employee was stepping onto a barge when they slipped on a wet surface and fell on their knee. The employee sustained a torn ligament in their knee requiring hospitalization and surgery.

After moving a barge lid, an employee was walking down the stairs on the barge when they slipped and fell approximately 15 to 20 feet, reuslting in a head injury.

An employee was using an excavator on a barge to scoop and remove fertilizer product stored in the cargo area. As the employee was transporting the skid-steer by chains and hoisting equipment from the dock to the barge, the employee fell approximately 10 feet off the skid-steer bucket to the cargo hold area below. The employee suffered a concussion.

Swingmen were performing discharge of an iron ore vessel. The discharge process consists of gathering remaining product into the center of the hold to facilitate removal by crane. At approximately 11:45 PM, a swingman was descending a ladder into a hold when he lost his footing and fell approximately 10-15 feet to the deck of the hold. The employee sustained fractures to their back and left leg.

An employee was on a bulk carrier ship. While removing lashing from wind turbine components, the employee lost balance and fell approximately 6 - 7 feet from a hatch to the deck of the ship. The employee was hospitalized with a head injury, and a fractured wrist, and required surgery.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee was drilling a hole into the sealed hold of a vessel so a marine chemist could test its atmosphere. Upon drilling the hole, a gas that was under pressure was released and caught fire at the drill motor, where the employee was holding it. The employee was burned.

An employee was performing restoration activities outside a 45-gallon condensation tank of a boiler system. As they were performing post-maintenance activities after repairing one of the two discharge pumps, one of the discharge valves would not open. The employee closed the intake pump to cool off the system and open the discharge valve. Two employees opened the inlet valve to return the tank to service. After they cracked open the inlet valve, a side wall of the tank blew out, causing the injured employee to suffer steam burns to half their body.

An employee was testing and troubleshooting the gang cylinder valve located in the gang area of the sawmill. The employee's fingertip was amputated by the gang cylinder valve.

An employee was unlocking containers on deck. The employee was de-lashing while standing on the edge of the lid. The lashing bar he was holding came off the cone, causing him to turn 90 degrees and strike a railing behind him. The employee sustained four fractured ribs.

An employee parked a side-by-side on the fixed internal ramp aboard a cargo ship. They exited the side-by-side and went to inspect the cargo below. The side-by-side rolled toward the employee and struck them as they were walking toward the edge of the ramp. The employee was knocked off the ramp and landed on the lower deck approximately 8 feet below. The employee was hospitalized with a fractured shoulder.