An employee was using a press, a spacer, and a lift. The press and the spacer were being used together but were not permanently affixed to each other. At the end of the order, the employee clamped the spacer and the press together with a C-clamp and tried to remove them from the operation by flipping the press over. His fingers were pinched in the gap between the press and the spacer next to the C-clamp.
On August 1, 2024, an employee was working on a press and dumping scrap material from the center piece to a scrap barrel when their finger became caught in the hole of the center piece and was crushed between the center and the edge of the roller on the conveyor. The employee sustained an amputation of three-quarters of their finger.
An employee was operating a forklift and unloading a truck. After the truck was unloaded, the employee got off the forklift and proceeded to adjust the dock plate with a hook tool. The dock plate slipped and the employee went to adjust the plate with their hand when their left middle finger got caught. Their finger was amputated above the first joint.
An employee was rotating a carbide granulator blade when his finger was caught between the blade and a stationary part of the machine. The employee's right middle finger was partially amputated and they suffered an avulsion to the right ring fingertip.
An employee was using a CNC metal lathe machine in manual mode to check that the thread blocking tool made contact with the jaws. As the employee was manually spinning the spindle, his index fingertip was crushed between the spindle's jaws and the grooving insert, resulting in a fingertip amputation.
During a material handling operation, an employee's fingertip was caught under an air conditioning unit as the unit was lowered onto a cart. The employee's fingertip was amputated.
An employee was removing a bolt from a tractor hub when their right index finger was caught between the hub and the frame. The employee's fingertip was crushed and the employee was hospitalized.
More severe injuries in this industry (NAICS 333519)
Three employees were engaged in horseplay when one employee suffered a laceration to the abdomen, caused by a pocket knife. The employee was hospitalized.
An employee was standing on a step ladder and operating a hydraulic jack. The jack began shifting, causing the ladder to tip to the left. The employee caught himself as he was stepping down from the third rung of the ladder. When he stepped to the floor, his left foot rolled and twisted under his body weight, resulting in fractures to his tibia and fibula above the ankle.
On August 1, 2024, an employee was working on a press and dumping scrap material from the center piece to a scrap barrel when their finger became caught in the hole of the center piece and was crushed between the center and the edge of the roller on the conveyor. The employee sustained an amputation of three-quarters of their finger.
An employee was removing grating to change metal chip hoppers located in a pit. The employee lost his balance and fell approximately 12 feet from the grate, landing in the metal chip hopper. The employee sustained a sprained right foot, a left foot fracture, and a fractured L5 vertebra.
An employee was using a hammer to hit a steel bearing and dislodge it from a shaft. A small piece of the bearing broke off and embedded in his stomach.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.