Pikes Peak Christian School

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee was watching students perform their daily tasks. A student who had been vacuuming the floor punched the teacher in the chest. She was hospitalized with chest pain, a fast heart rate, and vertigo.

An employee was coming from the patio area to replace a trash can. He was carrying the trash can and walking toward the entrance of the cafeteria when he tripped over the rubber mat that precedes the ramp. He fell to the ground and sustained a torn ligament in his left shoulder.

An employee was standing in the parking lot while waiting for another employee to move a cart with a sign when they were struck by a vehicle, resulting in four fractured ribs.

An employee stepped out of her office, turned to lock the door, turned back, slipped, and fell. She suffered a broken right femur and was hospitalized. There were water droplets on the floor from a wet umbrella.

An employee was on a ladder that was leaning against a wall inside a multipurpose room. He was running wiring through the walls to install sound equipment. When he reached up to pull a wire, the ladder slid down the wall to the floor. The employee fell on top of the ladder and struck the floor, fracturing multiple bones in his face and his left hip.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.