Stanley Black and Decker

An employee was walking up the stairs in an office area. Their right foot caught the edge of the stair at the top of the stairwell and they fell forward. The employee sustained a neck fracture.

An employee was moving a coil of metal with a crane using a C-hook. As he was moving the hook, his left hand was caught between it and a second coil of metal on the floor. His middle finger was pinched between the spine of the C-hook and the edge of the metal coil on the floor. He suffered an amputation to the flesh at the tip of the finger, as well as a fracture to the fingertip.

An employee rotated an arbor into position for the next setup of the slitter. The inward movement pinched the employee's left thumb between the arbor and the arbor lock. The employee's left thumb was medically amputated just below the knuckle.

An employee was stepping down from the back of a shuttle/vehicle and landed awkwardly resulting in a fractured ankle.

An employee felt dizzy and lightheaded while working in the black oxide room with chemicals. The employee was hospitalized with chemical burns to the lungs, chemical irritation, and skin blisters.

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

An employee was working on a portable stainless-steel vessel equipped with a butterfly valve at the bottom. The employee used a crane to raise the vessel and connected an airline to the valve control. Upon activating the compressed air supply, the valve opened. While holding the bottom of the vessel with their left hand, the airline disconnected and the valve closed on their left index fingertip. The employee sustained an avulsion of the fingernail, an open nondisplaced fracture of the distal phalanx, and partial amputation of the fingertip.

An employee was in training to learn how to change steel dies on a culvert machine. The employee was on top of the machine when the handheld control was activated, engaging the machine's auto-run function. The employee's feet were dragged into the roller dies, resulting in a left ankle fracture, a laceration between the ankle and knee, and amputation of the the big toe and second toe on the right foot.

An employee was walking up the stairs in an office area. Their right foot caught the edge of the stair at the top of the stairwell and they fell forward. The employee sustained a neck fracture.

An employee was operating a clipper machine and contacted maintenance when they noticed the machine was not working properly. Maintenance worked on the machine. While verifying that the machine was fixed, the employee's left index finger was amputated above the first knuckle.

An employee was feeding a strip of steel into a power press when it activated and contacted the injured employee's left hand. The employee suffered amputations of the first two digits of the hand.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.