Fall or jump from vehicle in normal operation, nonroadway · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at P & G Steel Products Co, 54 Gruner Road, BUFFALO, NEW YORK 14227
on — Fractures, affecting the leg(s), unspecified.
Final narrative
A temporary employee was moving a steel coil using a forklift when the coil slipped off the forks, causing the vehicle to rock. The employee fell out of the vehicle to the floor and a fork from the vehicle came off and struck their right leg. They were hospitalized for a right leg fracture.
HospitalizedLeg(s), unspecifiedForklift, order picker, platform truck-powered
An employee was operating a forklift to move panels around the dock area when the vehicle struck a joint where the two floors meet. The employee lurched forward and struck his head on the steering wheel. The employee then fell from the vehicle and sustained a dislocated disc in their back, requiring hospitalization.
An employee was standing inside a semi-trailer when the driver of the semi-trailer pulled away, causing the employee to fall backward and strike their head on a steel dock plate. The employee suffered a skull fracture, a fractured L1 vertebra, a broken coccyx, a laceration/abrasion to the head, and a brain bleed.
An employee was riding an ATV, catching up with a stray cow to return it to a pen. The ATV tire struck a hole or other obstacle, causing the employee to be ejected and fall to the ground. His leg was broken and he was hospitalized.
An employee was driving a van in reverse when they fell out of the vehicle and landed on the ground in the parking lot. The employee sustained a fractured left hip.
More severe injuries in this industry (NAICS 336370)
An employee was verifying light curtain function at a load cell tester when their right index finger was amputated by a hydraulic cylinder above the middle knuckle.
An employee was positioning an overhead crane to stand up a skidded coil when the coil swung back. The employee was caught between the swinging coil and another coil sitting on a coil pad, resulting in hospitalization due to a loss of consciousness and a pelvic injury.
An employee was performing general cleanup duties when they collapsed and passed out due to heat exhaustion. They were hospitalized for heat exhaustion, dehydration, and acute renal failure.
A temporary employee was helping a forklift operator by holding metal sheets to steady them as they were placed on a rail for feeding to a stamp machine. The operator lowered the forks with the blanks (weighting approximately 750 pounds). The temporary employee's right index finger was caught between the metal and the feeding rail. The finger was crushed and partially amputated through the bone.
An employee was using a mechanical trim press to trim flash off metal parts. The employee was loading a part to be trimmed when the press cycled and crushed the index fingers on both of their hands. The employee sustained a fingertip amputation. The machine was not guarded at the time.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.