Other fall to lower level 6 to 10 feet · Fractures and dislocations
At a glance
Federal OSHA recorded a severe workplace injury
at Lockheed Martin, 225 North Flightline Ave., EDWARDS AFB, CALIFORNIA 93524
on — Fractures and dislocations, affecting the multiple body parts, n.e.c..
Final narrative
On June 27, 2023, at 2:30 p.m., a pilot was returning after a test flight of an F-35 aircraft. After aircraft recovery, the pilot exited the aircraft via the integrally mounted aircraft access ladder. During his descent, he tripped on the third ladder step and fell approximately 6 feet, resulting in a dislocated left shoulder, a compound dislocation of the left elbow, and stable fractures of the left 7th and 8th ribs.
HospitalizedMultiple body parts, n.e.c.Airplane-jet or turbine engine
An employee was troubleshooting a dust collector when they sustained partial amputations to three of their right fingertips from the spinning rotor of the motor.
An employee was using a clutch spreader tool during a training activity. When he applied pressure to the tool to release belt pressure, his left index finger came in contact with a spring sheave roller. The finger was amputated just below the nail.
A 370-pound piece of aluminum was being lifted with a jib crane and a calibrated suction lifting fixture. The aluminum fell, landing on an employee's left foot about 3 feet below. He was hospitalized; his big toe had been broken, and the other four toes were medically amputated.
An employee was in a final assembly building, seated on a workbench chair with wheel casters, working on equipment wiring. The chair slid out from under the employee, who fell about 2 1/2 feet to the concrete floor and suffered a broken hip and right femur.
An employee was preparing a tank car for loading while chipping away solidified product in the manway opening of the tank car. A pressure noise within the tank car startled the employee, causing him to stumble backward and fall approximately 10 feet over the guard railing at the chemical loading rack to the ground. The employee suffered fractured vertebrae, a fractured right wrist and ankle, and a dislocated jaw.
An employee was installing an electrical tray remover from a ladder. As he was descending, his missed a step and fell 6-7 feet to the floor. The employee suffered a head injury.
Two employees were installing spray foam insulation in the attic of a new residential construction. The injured employee fell 8 feet from an A-frame ladder to the floor. The employee suffered lacerations, abrasions, and a head injury.
An employee was on a raised platform attaching wires to electrical boxes. The employee fell approximately 8 feet to the floor below and struck an exit sign on the way down, resulting in an injury to his face.
An employee was in a forklift man basket fixing a garage door opener when they fell approximately 8 feet to the concrete ground below. The employee suffered head and back injuries as well as kidney bruising.
More severe injuries in this industry (NAICS 488190)
Two employees fell from an access bridge while entering an aircraft to perform maintenance. They landed on the ground about 20 feet below, where one of them lost consciousness. One employee sustained a fractured knee and another employee sustained a back strain/sprain. Both employees were hospitalized.
An employee experienced sharp pain in his lower torso area while loading baggage into the front cargo pit of an aircraft. The employee sustained a hernia.
The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.
On September 11, 2025, an employee was lowering a railing system on an aircraft fueling cart when his gloved right ring finger was caught in the folding railing system, resulting in a fingertip amputation that required hospitalization and surgical reattachment.
An employee was working at ground level when an aviation engine cylinder weighing 30 pounds fell from a seven-foot high shelf and struck the employee on the head. The employee suffered a fractured skull and was hospitalized.
The injured employee was assisting a Department of Homeland Security (DHS) enforcement operation. During an apprehension, officers returned fire at a subject and struck the employee with a bullet. The employee sustained a gunshot wound to their right hand.
The injured employee was assisting in the disassembly phase after a radar array had been lowered and secured. The crew began removing load bearing pins from an overhead crane to free the radome. A load bearing pin was stuck. The injured employee went to remove the pin manually as a second team member applied pressure from the opposite side. The pin unexpectedly released and struck the injured employee s right thumb, resulting in partial amputation of the distal phalanx including an open distal phalanx fracture and nail bed laceration.
At about 3:10 p.m. on October 3, 2025, an employee was inspecting a car. Two dogs that had been in another car were leashed and tethered to a bollard. As the employee inspected the first car along with a narcotics detection dog, one of the other dogs came loose and attacked the narcotics dog. The employee was separating the dogs when the other dog bit his left ring finger. The last joint of the finger was injured and part of it was bitten off.
An employee was preparing a bundle of green onions for chopping. While holding the bundle in his left hand, he made his first cut using a 9-inch kitchen knife held in his right hand. The knife contacted the tip of his left thumb, resulting in an amputation of approximately 0.5 inches of the thumb that required hospitalization.