Skana Aluminum Company

On July 14, 2016, at approximately 1:40 a.m., an employee was located at the end of the line where aluminum was being rolled onto a coil. Wearing cotton gloves, the employee was checking for edge cracks and used sand paper when he observed a spot. The roll was moving at approximately 900 feet/minute when the operator of the machine saw the coil buckle and hit the E-stop to prevent damage. While using the sand paper, the employee's left hand/fingers were severely crushed between the moving coil and the roller, requiring hospitalization.

An employee was hospitalized after a pump seal failed during the repair of a pump. Pennzoil 50H and X850 oil blew into the employee's eyes, throat, and nose, resulting in inflammation and irritation.

On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.

An employee was examining a machine when a part moved up and amputated a fingertip on their left hand.

An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.

An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.

An employee's right hand was caught in a wire drawing machine, resulting in amputation.

A maintenance technician was investigating a tool issue. He was pressing the tool clamp/unclamp button with his right hand when his hand slipped off the button, causing the spindle to clamp on his distal left index finger, resulting in amputation.

An employee had just fixed a loose aluminum coil on a rack while raised about 11 feet into the air on a forklift. While he was being lowered, he fell from the forks to the floor, suffering two fractured ribs, a punctured lung, and a fractured cervical vertebra. He was hospitalized.

An employee was troubleshooting a caster machine. While removing a cap cover, the catch pan moved up and caught his right arm against the caster blocks. He suffered lacerations and an open break of the ulna. He was hospitalized.

At 11:27 a.m. on March 15, 2025, an employee was transferring film to start a new roll when the winder shaft failed to seat properly in its cradle. The employee was knocking the unseated shaft down when his right thumb was caught. The employee sustained an amputation to right thumb.

Two employees were riding in a utility terrain vehicle down a loose gravel path. The vehicle's front wheel dug into the gravel, and it rolled over onto its side. The injured employee struck the interior of the vehicle (including the steering wheel) before landing on the driver. The injured employee suffered a 6-inch head laceration, a broken collarbone, and six broken ribs.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.