Caught in running equipment or machinery, unspecified · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Tenneco Inc., 1111 Izzak Walton Rd, SEWARD, NEBRASKA 68434
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was performing an air check on an articulated dump truck when their finger was pinched in the clamping mechanism on the lift assist. The employee's right middle finger was amputated above the distal interphalangeal joint.
A maintenance employee was conducting repairs on the conveyor belt of an automatic palletizer. The employee's shirt fell in front of a sensor causing the equipment to energize. The employee's right middle finger was caught by chains within the conveyor belt motor resulting in a partial amputation.
An employee was responding to a work order relating to a machine that was not cooling when the lid of the machine lowered onto the employee's thumb. They sustained a left thumb fracture and partial amputation that required hospitalization.
An employee had just replaced a broken sprocket and put in a new chain on a high-volume oil conveyor. The chain seized up. As he tried to free it, it took off and his left index finger was caught between the chain and the sprocket. The fingertip was amputated halfway up the nail.
On January 14, 2020, an employee was clearing a blockage in the gate valve of the deaerator tank located in the boiler room. As the employee was getting the gate valve fully nested, the blockage cleared and the employee was sprayed with hot water (225 F). The employee was hospitalized with burns to the face, neck and shoulders.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
An employee was changing out the sensor wire on a sensor cap press. The machine actuated after the sensor was replaced, resulting in the amputation of the employee's left little finger.
A temporary employee was working on a plastic extrusion machine. The employee's left index finger got caught between the rotary gears, resulting an amputation to the finger.
An employee in the warehouse area was operating a semi-automated machine and noticed that the machine was not operating properly. He went to use a paper towel to clean the main rollers and his left hand was caught by the rollers. Two fingers were crushed.
An employee was walking to collect trash from a box at a work cell parts stand. A leg of the stand caught the employee's foot, causing the employee to lose balance, fall to the floor, and suffer a broken left elbow.
An employee's leg became entangled in a printer power cord. As she stepped backward, she got hung up and fell. She landed on her right side and suffered a broken right hip.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.