American Steel and Aluminum, LLC

On January 8, 2025, two employees (one of them a temporary employee) were using a floor crane with a magnet to move steel beams from a platform to a container. A beam fell from the magnet and crushed two fingers on the temporary employee's right hand. He sustained a crushing injury to his right ring finger and an amputation to his right middle finger.

An employee was moving a loaded lift from an aisle when it became wedged in the aisle and abruptly stopped, throwing the employee. The employee suffered a concussion, and fractures to two neck vertebrae and the left scapula.

An employee was operating a coil slitter when his finger became caught in the roller, resulting in amputation of his right index finger.

An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.

An employee was working as a fire watch. The employee was exposed to anhydrous ammonia and was not able to see while climbing down a ladder due to eye irritation. The employee fell and was hospitalized for a broken ankle.

An employee was working from a ladder and adjusting a spreader guide roller with a T-handle Allen wrench. The employee came into contact with an electrical junction box/wires, was shocked, and fell off the ladder to the concrete floor. He suffered a broken right-side rib, a puncture in the right lung, and an electrical shock burn to the right palm.

An employee was on a 10-foot ladder, working to insulate 24-inch piping that was 12 feet above the ground. The pipe jack/steel tube used to raise the pipe slipped, causing the steel tube to strike the employee's face. The impact caused the employee to fall off the ladder and sustain fractures to their left tibia and fibula.

An employee was on a rooftop, supervising the lifting of a 30' x 30' structure manufactured from I-beams. The employee was knocked to the ground and the suspended load settled on them. The employee sustained a head injury, loss of an eye, and fractured ribs.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.

An employee was removing a roll (tooling) from a machine when their left little finger was pinched between the roll and the machine, resulting in a partial amputation.

An employee was rolling a piece of steel in the belt of a shape roller machine when his finger was pinched between two pieces of steel. His right ring and middle fingers were amputated.

An employee was cutting a length of steel coil when he noticed the steel might have cross-break defects. He used his gloved hand to feel for and clean the defected spots when his glove got caught in the measuring wheel, which rolls along the top of the steel to ensure accurate cuts. The employee's arm was pulled down into the machine until his body was stopped by a support bar that goes across the machine. The employee's arm was fractured at the elbow and required hospitalization.

An employee fell while exiting a trailer. The employee landed on their left side on the pavement, suffering multiple broken ribs on the left side. The employee was hospitalized.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee had been loading a double deck press. The employee saw a mold had been sent in with the C-hook still attached on the belly bar. As he went to remove the hook from the mold, his right thumb got caught on the C-hook. The employee's thumb was partially amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.