Ignition of clothing from controlled heat source · Third or fourth degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at ASDA Enterprises Inc, 6320 McHenry Street, BURLINGTON, WISCONSIN 53105
on — Third or fourth degree heat (thermal) burns, affecting the multiple trunk locations.
Final narrative
An employee was welding a kick bar onto the rear of a hopper on a trash truck. His clothing caught fire, resulting in second- and third-degree burns to his chest and stomach area.
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 562111)
An employee was operating the compaction levers on a truck when a motor vehicle crashed into the back of the stopped truck. The employee sustained fractured ribs and contusions.
A maintenance employee was moving a forklift from the loading dock when the forklift fell off the dock. The employee was struck by the overhead portion of the roll bar, injuring his right knee. He was hospitalized and underwent surgery.
An employee was standing on the driver side rear step of a trash truck while traveling down a road to collect residential trash. The employee went to signal the driver and slipped off the step while the truck was traveling 8-9 miles per hour. He fell 18 inches to the ground and was hospitalized with a fractured ankle that required surgery.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.