Caught in running equipment or machinery during regular operation · Avulsions, enucleations
At a glance
Federal OSHA recorded a severe workplace injury
at Johnson Controls Inc., 3120 N. Mead St., WICHITA, KANSAS 67219
on — Avulsions, enucleations, affecting the fingertip(s).
Final narrative
An employee was removing a part from a brake press when the machine's backstop came back and caught the employee's finger against the bottom die. The employee's fingertip was crushed and degloved, and the employee was hospitalized.
An employee was manually adjusting a wooden pallet when he lost his balance and fell to the floor. The pallet fell on the employee's abdomen and they were hospitalized with internal bleeding.
On July 3, 2024, at approximately 8:00 AM, an employee was installing a pulling sheave in an electrical gear when they received a high-voltage electrical shock and sustained arc flash burns.
An employee was installing a base pan to the rails on a lift table. The conveyor was lowered to the home position and the employee's left foot was pinned underneath the table, resulting in a fracture.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333415)
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was observing expansion rods on a coil expander going into a coil to ensure copper stubs weren't being bent. His left hand was caught between the locking block and locking block clamp on the power press machine, resulting in partial amputation of his left little finger from the distal interphalangeal joint.
An employee was setting up a press brake and rolling over a die when the tip of their left little finger was caught between the horizontal working surface of the press brake and die. The employee sustained partial amputation of their fingertip.
An employee was working to remove an access panel to begin performing maintenance on a machine. The set pins on the bottom of the panel were broken. The bottom kicked out and fell, striking the employee's left foot and resulting in a fracture to the big toe.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.