Phoenix Steel Service, Inc.

An employee was walking/moving a walkie (material handling equipment) when it struck and fractured their right leg. The employee was hospitalized.

An employee was was exiting a car they were detailing when a malfunction caused it to move. The employee was pinned between the car door and a pole, suffering a lower left leg fracture and crushing injuries.

An employee was operating a tug that had been re-tagged due to faulty brakes. As the employee approached the designated parking area, he slowed the tug using the clutch and then exited the tug. He went to stop the tug from colliding with a concrete wall when his right ankle became caught between the tug and a parking stall barrier. He sustained a fractured ankle and was hospitalized.

An employee was on a tugger. He was backing up to pick up a stack of pallets. While aligning the tugger with the pallets, his left leg was caught and broken between the tugger and a storage rack.

An employee was operating an electric pallet jack. While standing beside the equipment, the pallet jack lurched forward, pinning the employee's leg against racking. The employee was hospitalized with a fractured right ankle.

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.

An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.

An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.

On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.

An employee was working to deliver mail to an apartment building. She was waiting for a customer to move, to obtain clearance to the mailboxes. The door swung inward and closed on her right little finger. The top half of her finger was surgically amputated.

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

On October 30, 2025, an employee was working to adjust a stackable metal shipping container. As the container dropped into place, it caught the employee's hands in an area between the upper and lower cross-members. The employee suffered a laceration to the left ring finger that required stitches, bruising to the right ring finger, and fractures to the right middle finger that necessitated medical amputation of the fingertip.

An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.

An employee was setting up communication equipment for a meeting. They were walking and tripped over a speaker on the ground. The employee sustained a leg injury.