Federal OSHA recorded a severe workplace injury
at Dodson Tye Machine Works, Inc, Parish Rd 180 (Dutchtown Rd), HOMER, LOUISIANA 71040
on — Amputations, avulsions, enucleations unspecified, affecting the Other finger(s) n.e.c..
Watch Dodson Tye Machine Works, Inc — freeGet an email when a new federal OSHA severe-injury report for Dodson Tye Machine Works, Inc is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was clamping off a polish rod on a pumping unit so that the wrist pins could be removed, when the clamp slipped causing his fingers to be crushed between the carrier bar and the polish rod clamp. This resulted in a partial amputation of his right index finger.
HospitalizedAmputation Other finger(s) n.e.c. Pumps except oil well
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was installing a hydraulic extension cylinder in a tow truck when their leg was caught between the cylinder and the truck frame. The employee was hospitalized with a broken tibia, which required surgery.
An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.
More severe injuries in this industry (NAICS 333999)
An employee was working on an assembly line in the production facility. He was on the south part of the aisle, checking for debris in the system, and went to remove a screw. His left foot became caught in a wheel on a track along the assembly line. All of the toes on his left foot were amputated.
A maintenance employee was using an air wand to clean equipment. The air wand became caught in the rollers that were turning and the employee's left arm was pulled into the equipment. Their arm was crushed to the elbow and the fifth digit on their left hand was amputated.
On July 3, 2024, at approximately 8:00 AM, an employee was installing a pulling sheave in an electrical gear when they received a high-voltage electrical shock and sustained arc flash burns.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.