Struck by other falling object n.e.c. · Multiple surface and flesh wounds
At a glance
Federal OSHA recorded a severe workplace injury
at D&R Machine Company, 4131 Alby St, ALTON, ILLINOIS 62002
on — Multiple surface and flesh wounds, affecting the Lower leg(s).
Final narrative
An employee was operating an overhead crane to move a 31" x 27" x 10" piece of machined metal with a hole through the middle weighing approximately 1,350 pounds to prepare for the next welding operation. The material was 16-20" above the ground when the lift strap broke and the material fell onto the employee's lower legs. This caused him to fall backward and the material landed on his left foot. The employee sustained bruising and scraping injuries to the legs from the knees down to the ankle, as well as a foot injury.
Hospitalized Lower leg(s) Metal sheets, ingots, bars semi-finished
An employee had just finished moving a part with an overhead bridge crane and was beginning to move the crane out of the work area. He removed the hooks and chains from the part and began to lift the crane out and away from work area. As the hoist chain was moving upward, the chain hook caught the edge of the part. As the employee tried to keep it from falling over, it fell on his leg and pinned him to the ground. He suffered pain and swelling and was hospitalized.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was positioning dunnage on a trailer while pipe was unloaded from a forklift. A pipe fell and the employee's right thumb and index finger were caught between the pipe and a piece of dunnage. The thumb was crushed, and the index fingertip was amputated.
An employee was using a lifting sling on a crane to move a straight-bar bundle and place it on top of an existing bundle. When moving the lifting sling, it became pinched between the bundle and a wood cleat. The bundle then fell onto the employee's left foot, resulting in crush injuries.
An employee was stacking metal tubes using a forklift. A stack became unstable and the employee got out of the forklift to steady it, instructing his helper to get into the forklift. The forklift movement caused some tubes to fall and strike the employee, resulting in an open fracture of his left hand.
An employee was setting up a flexible gear coupling hub in a lathe, preparing to bore it out to fit a shaft. The hub assembly was not secured in the chuck when the crane support was removed, and the employee's right little finger was caught between the hub assembly and the inside of the lathe. The fingertip was amputated.
An employee was using a crowbar to loosen a flat bar when the crowbar struck the employee's right eye. The employee was hospitalized and required surgery.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.