Exposure to environmental heat outdoor · Heat stroke, syncope
At a glance
Federal OSHA recorded a severe workplace injury
at S. J. Louis Construction, Inc., Indian Service Road 5017, SHIPROCK, NEW MEXICO 87420
on — Heat stroke, syncope, affecting the BODY SYSTEMS .
Final narrative
An employee was working in a trench in 93-95 degree weather. He became light-headed and was taken to the hospital with heat stroke.
On October 7, 2025, employee was installing mulch with a landscape crew. At around 2:15 PM, the employee took a break and started to feel cramping/pain. The employee was taken to the hospital with rhabdomyolysis due to heat exhaustion.
A temporary employee was on top of a cane wagon, throwing cane down to the ground (i.e., planting). He reached the end of the field row and started to feel ill. He experienced cramping and headaches due to heat exhaustion.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
On October 7, 2025, employees were conducting trenching operations for the installation of a new sewer line system. The excavator's bucket was detached and put inside the trench as it was being exchanged for a different-sized bucket. An employee entered the trench with a shovel to move some dirt located at the front end of the pipe. The excavator bucket shifted and slid, striking the employee s right foot and trapping it against the ground. The employee sustained a fractured right tibia.
Employees were working to dislodge a large truck that was stuck in a rut using tow straps and a front-end loader with the bucket removed. An employee connected the straps to the loader and truck and another employee slowly engaged the loader to close the coupler. The injured employee's arm became caught in a pinch point. The employee was hospitalized with a fractured arm.
An employee was lifting a piece of 30-inch line stopping equipment using a jack screw. A lifting eye weld snapped and the load dropped. The end of the jack screw then landed on the employee's heel and crushed it. The employee was hospitalized.
An employee was servicing an exterior mounted environmental control unit while on a 10-foot ladder. He pushed through a pre-made knockout hole on the panel. Upon bringing his arm down, a sharp area along the panel frame lacerated the top of his hand. The employee required surgery.
On 7/31/2025, an employee was training to ride an ATV when it went into a draw and she went over the front of the ATV, landing on the ground. The employee sustained a fractured arm.
An employee was standing behind a frac pump. A discharge hose failed and the employee was burned by hot water on the left upper abdomen. The employee was hospitalized.
An employee working as a contracted firefighter was using a bulldozer to push back an active fire line when they became entrapped in flames, resulting in first- and second-degree burns.
An employee was assisting with the delivery of pipe racks to the drilling rig. The driver was releasing the tie-down lock straps that were holding the pipe racks on the trailer. When the last strap was released, one of the pipe racks rolled off the trailer and struck the employee while they were on the passenger side of the trailer bed. The employee sustained an open wound to the hand and fractures to their left leg and spine.