Texas Materials Group Inc.

An employee was running during a fitness test and experienced heat illness, chest pains, and felt faint. The employee sustained heat exhaustion.

At about 10:30 a.m. on August 7, 2025, a warehouse technician working for Tnemec Company, Inc., began sweating profusely a half-hour into their shift. The employee was using a forklift to move staged pallets of paint to a shrink-wrapper, shrink-wrap the pallets, and then load the pallets onto a truck using a forklift. The employee became ill about two hours later and was hospitalized for heat-related illness.

An employee was performing job duties and became overheated. The employee was hospitalized for heat-related illness.

On July 29, 2025, an employee working near a metal furnace. Toward the end of his shift, he was charging a furnace and began to experienced heat exhaustion. He had also been in areas of elevated temperatures due to heat sources such as direct sunlight and a combustion engine. The employee was hospitalized with dehydration.

An employee was working near molten metal and experienced heat illness symptoms including cramps. The employee was hospitalized.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.