VMC Specialty Alloys LLC

On May 20, 2024, an employee was placing ingot tongs onto an aluminum ingot to lift it from a casting pit using an overhead crane. The employee placed his right hand on the ingot tongs to position them when the tongs engaged causing a compound fracture to their right index finger. This resulted in amputation of the finger at the first joint.

An employee was injured when two, 19-inch diameter, 16-foot-long aluminum billets weighing approximately 7,000 - 10,000 pounds each, rolled off the forks of a fork truck while he was stacking steel I-beams as spacers so that the aluminum billets could be placed in the homogenization oven. The fork truck lost hydraulic power to the forks which were holding the billets. This caused them to tilt forward (down) and strike the employee. The billets had an approximate average temperature of at least 500 degrees Fahrenheit. The employee suffered second degree burns to the left hand, a fractured and displaced left ankle, a left distal fibular fracture, multiple fractures on the left and right feet and toes, and third degree burns from the ankle to the waist of the left side. The employee was hospitalized.

An employee was running during a fitness test and experienced heat illness, chest pains, and felt faint. The employee sustained heat exhaustion.

At about 10:30 a.m. on August 7, 2025, a warehouse technician working for Tnemec Company, Inc., began sweating profusely a half-hour into their shift. The employee was using a forklift to move staged pallets of paint to a shrink-wrapper, shrink-wrap the pallets, and then load the pallets onto a truck using a forklift. The employee became ill about two hours later and was hospitalized for heat-related illness.

An employee was performing job duties and became overheated. The employee was hospitalized for heat-related illness.

An employee was working near molten metal and experienced heat illness symptoms including cramps. The employee was hospitalized.

An employee was performing general cleanup duties when they collapsed and passed out due to heat exhaustion. They were hospitalized for heat exhaustion, dehydration, and acute renal failure.

An employee was using a pry bar to remove a piece of aluminum cone from a mold on the cone line. The cone broke loose and the employee's left middle finger was caught between the pry bar and the cone line frame. The employee's fingertip was partially amputated.

On February 6, 2025, an employee was walking in the parking lot when they slipped and fell to the pavement, resulting in a concussion.

An employee was machining a trunnion using a grinding rig when their left hand was caught between the grinding stone and the trunnion, resulting in fractures to the middle, ring, and little fingers, as well as severe damage to the skin and amputations of the middle and ring fingers to the distal knuckle.

On August 7, 2024, a maintenance technician was descending a fixed cage ladder when the ladder broke and they fell approximately 12 feet to the concrete ground. The employee sustained head injuries and fractured ribs.

At 3:17 p.m. on July 17, 2024, an employee was using a shovel to clean molten metal from the surge bowl of an aluminum launder system when the metal splashed onto the employee's lower left leg. The employee suffered third-degree burns.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.