Georgia-Pacific Leaf River Cellulose, LLC

An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.

An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.

After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.

An employee was loading black liquor into a tanker truck using a swivel arm. The arm caught and pinched his right middle finger as it moved, resulting in a partial amputation to the first knuckle.

An employee was visually inspecting the drive line for a conveyor. There was an explosion in the conveyor, and the employee suffered second- and third-degree burns to both forearms.

An employee was driving forklift with a load when the forklift hit a guardrail and the employee fell to the ground, resulting in a broken elbow, broken shoulder, and lacerations.

An employee was putting a chain back on a sprocket. The gearbox and sprocket contained two drive chains connected to the lowerator (vertical conveyor) and counterweight assembly. The employee received an alarm indicating that one of the chains had gone slack. While the employee was putting the chain back on the drive sprocket with tongue and groove pliers, the weight of the chain and counterweight fell back in place on the sprocket, pulling the employee's left hand into a pinch point. The employee's ring fingertip was amputated up to the fingernail.

While troubleshooting equipment, an employee tripped on the turntable of the conveyor system and fell to the floor, fracturing their right femur.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.