Struck by propelled, falling, or suspended object unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Helmerich & Payne International Drilling Company, Rio Lobo State C 312H (Rig 496), PECOS, TEXAS 79772
on — Fractures , affecting the Leg(s) unspecified.
Final narrative
An employee was changing out the elements in the double-rotating head. The peg that was welded to the rig floor, where the double-rotating head was being stored, broke at the weld causing the metal rotating head to fall and strike the employee's left leg and fracture it.
Hospitalized Leg(s) unspecified Drilling and extraction machinery unspecified
More severe injuries at Helmerich & Payne International Drilling Company
An employee was on mud pumps cleaning out the bay with a pressure washer when the tip of the washer wand came off. Diesel fluid was injected into his finger as he was replacing the wand tip.
An employee had been lowered down to a catwalk with a hoist. He was unhooking the hoist from the rotating head when it fell over. His left leg was pinned between the rotating head and a pipe retention post, resulting in swelling and inability to bear weight on his leg.
A derrickman was trying to latch a stand of drill pipe at the derrick board. The stand pulled him off the board, pinning his left forearm against the safety gate and breaking it.
An employee was opening the forks of a forklift to pick up a bag of casing protectors when his left ring fingertip was partially amputated between the fork and the forklift carriage. Impact gloves were worn at the time of the incident.
An employee was driving back to the rig from the water well and ran over a rattlesnake. He got out of his vehicle and walked to the rattlesnake, which bit his right middle finger. He was hospitalized.
An employee was activating the sprinkler system at a sports complex following recent maintenance to repair leaky pumps. When the system was activated, a section of newly installed 3-inch schedule 80 PVC pipe struck the employee, who lost consciousness. The employee suffered a broken jaw and a concussion.
An employee was cutting metal with a torch. A piece of metal struck the employee's left foot, causing multiple fractures to metatarsal(s). The employee was hospitalized.
An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.
An employee was repositioning a large casting with a chain. The chain slipped and landed on his hand, resulting in hospitalization with a fracture to his upper arm and a crushing injury to his thumb.
An employee was installing a rear suspension airbag beneath a hydro-excavation truck when the airbag slipped off the truck's frame and struck him in the face. The employee sustained multiple facial fractures and an intraparenchymal hemorrhage and was hospitalized.
More severe injuries in this industry (NAICS 213111)
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.