WICHITA, KANSAS—
CASE NEW HOLLAND INDUSTRY, LLC.
Pedestrian struck by vehicle or object propelled by another vehicle in nonroadway area · Traumatic injuries or exposures unspecified
At a glance
Federal OSHA recorded a severe workplace injury at CASE NEW HOLLAND INDUSTRY, LLC., 3301 S HOOVER Road, WICHITA, KANSAS 67215 on — Traumatic injuries or exposures unspecified, affecting the Head unspecified.
Final narrative
The injured employee was walking and cycle counting motors while another employee was using a forklift to stack additional motors. The forklift knocked a stack of motors over and one 4-cylinder diesel motor struck the injured employee in the head. The employee sustained a head injury.
Similar incidents · Same event type
COLUMBUS, OHIO—
Hamilton Parker Company, LLC.
The injured employee was walking through the warehouse. Another associate was driving a forklift with a pallet of large format tile (slabs) when the slabs began to tip. The injured employee ran over to stop the slabs from falling, but the slabs fell on his lower left leg/foot. The employee sustained fractures in his lower leg and foot. He was hospitalized and required surgery.
ATMORE, ALABAMA—
Birdsong Corporation
An employee was directing a truck driver to a dump site when the truck's peanut trailer slipped off the kingpin. As the trailer fell, a ladder attached to it lacerated the employee's ear. The employee was hospitalized.
ATLANTA, GEORGIA—
Delta Air Lines Inc
An employee was helping offload an aircraft. She was standing in the opening between a parked cart and an unoccupied aircraft tug when another vehicle struck a stationary bag cart, which then struck her. The employee suffered a skull fracture near the right eye, a right kneecap fracture, a nose fracture, and sinus damage, as well as soft tissue damage to the left calf and hip. She was hospitalized and required surgery.
HOUSTON, TEXAS—
Southwest Galvanizing, Inc.
An employee was cutting steel channels from a hanging rack that was being supported by a forklift. When they were finished, the forklift started moving the rack out of the area and a piece of material snagged one of the rack legs, causing the rack to tilt backward. The rack slipped off the forklift and struck the employee on his right side/lower back. He sustained a fractured pelvis and was hospitalized.
SOUDERTON, PENNSYLVANIA—
JBS Souderton, Inc.
The injured employee was standing by one of the stationary computers along the wall. There was a half-pallet located approximately 3 feet behind the employee that consisted of 12-pound boxes stacked six boxes high. A forklift was transporting a pallet that came in contact with the stationary pallet behind the injured employee, causing four boxes to fall and contact their legs. The injured employee was hospitalized with leg injuries.
More severe injuries in this industry (NAICS 333120)
HURON, SOUTH DAKOTA—
Riverside Industries LLC
An employee was working behind a stack of steel I-beams (stacked 2 columns deep and 4 levels high on the floor) while a forklift was pushing the stack. When the forklift took off the second-to-last beam, the last one was pushed over, causing it to fall to the ground and strike the employee. The employee sustained a fracture to the right leg.
BISMARCK, NORTH DAKOTA—
Bobcat Company
An employee was lifting a flat sub (sheet steel) in the flats robot cell (weld area). He was operating a hoist when his left little fingertip got caught between the lifting device hook and the flat sub. The employee sustained a partial transphalangeal amputation.
BALCH SPRINGS, TEXAS—
Altec Service Center
An employee was underneath a 35-foot boom truck and adjusting the transmission linkage when the truck jumped over the wheel chocks and rolled over the employee's right leg, resulting in a fracture.
NEW PHILADELPHIA, OHIO—
GRADALL INDUSTRIES, INC.
A crane was being used to lift a debris tank from a rack. The tank crushed the employee's right hand, causing amputations to the employee's right ring finger and little fingertip.
MADISON, SOUTH DAKOTA—
Manitou Equipment America, LLC
An employee was removing a small sheet metal part out of the die of the brake press. The foot pedal was pressed, causing the part to lift and crush their left thumb against the die. The employee suffered an amputation to the thumb tip including the loss of flesh and the fingernail.
More severe injuries in KANSAS
WATHENA, KANSAS—
Omya Inc.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
COFFEYVILLE, KANSAS—
John Deere Coffeyville Works
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
HAVEN, KANSAS—
Haven Steel Products Inc
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
MINNEOLA, KANSAS—
Vestas-American Wind Tech
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
MEADE, KANSAS—
Alliance Ag and Grain LLC
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.