Contact with hot objects or substances · Thermal burns degree unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Hayman Company, The Aventine, AURORA, ILLINOIS 60502
on — Thermal burns degree unspecified, affecting the Trunk and other upper extremities.
Final narrative
Two employees responded to an emergency call. They discovered a hot water heater leaking in the unit downstairs. The injured employee was going to change a valve. While removing a pipe that was tied to the drain, hot water shot out of the pressure-release valve. The injured employee sustained burns to his right arm and hand, left-side ribs, and torso.
Hospitalized Trunk and other upper extremities Pressurized water blast
An employee pulled out a bucket of hot oil from under the fryer. The employee then stood on the table to clean the back wall. He stepped down into the bucket of hot oil, resulting in third-degree burns to his left leg.
An employee was performing maintenance under a kettle. When he removed a tri-clamp on a transfer line, the hot fat and broth material in the kettle poured out onto his arm. The employee was hospitalized with burns.
After completing a run with an oil distributor truck, an employee was working to return (suction) the hot oil to the tank of the truck. When the employee opened one of the valves, hot oil (approximately 385 degrees) sprayed their face, resulting in first-, second-, and third-degree burns.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was using a water hose to clean debris out of the outfeed of a log conditioning vat. Water began entering the vat from the adjoining vat through a void in the separation wall at the infeed of the vats. As the employee was exiting the vat he had been working in using the access opening at the outfeed, hot water exiting the access opening entered the top of his protective hip wader. It pooled at the bottom of the wader and burned his left foot and ankle.
More severe injuries in this industry (NAICS 531312)
An employee was walking to inspect ceiling light fixtures and tripped on a 3'x5' mat that was covering an electrical cord. The employee fell and fractured their hip.
An employee was using an auger machine on an outside sewer line. While he was feeding metal rope into the sewer line, the rope came back and pulled his hand in, cutting his left middle finger. The finger was amputated from the distal joint to the tip.
An employee was moving an air conditioning unit into storage. A wooden 2x4 that was in storage fell and struck the employee's head, causing a brain bleed.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.