Road and Rail Services, Inc.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

An employee was working on a platform, raised 6 to 8 feet in the air, to get something off a rack. The employee fell from the platform to the ground and sustained a head injury and injury to multiple body parts.

An employee was preparing to unjam an auger shaft while standing on a forklift-elevated, job-made platform. The employee's wrench slipped off the equipment, causing them to lose their balance and fall. The employee landed on the ground 14 feet below and suffered fractures to the orbital bone, left elbow, and lower back.

An employee was using his left hand to push an axle down the line on a raised track work area while holding the remaining axle back with his right hand. A finger on his right hand was caught between the rail and the dust guard of the axle, resulting in a fracture and a laceration.

An employee was sampling a railcar in a storage yard. After sampling the railcar, the employee was climbing down the railcar ladder when he fell off the top step of the ladder to the ground, resulting in fractures to six ribs, his right arm, and two vertebrae.

Employees were watering a train at a train platform. One of them went to step over a hose, tripped, and fell to the ground. He suffered a broken knee. The employee was hospitalized for surgery.

Employees were performing maintenance operations on a railroad line when the machine experienced a load conveyor motor failure. While clearing the machine to allow for repairs, an employee pinned the left side of the swing conveyor. The operator on the right side then requested a slight bump to the left to align the right side for pinning. Once the swing was in position, the operator went to pin the right side and the chain tensioner failed, resulting in an abrupt release of the swing chain. The chain snapped back and struck the operator s right hand, resulting in a 1-inch laceration and a fractured fifth metacarpal. The employee was hospitalized and required surgery on the hand.

The injured employee loaded a container onto a railcar and then mounted the railcar to put in the locking mechanism for the container. The employee was struck by another container that a crane was loading onto the railcar and fell approximately four feet from the railcar to the concrete ground. The employee sustained fractures to their pelvis, shoulder, and two ribs.

An employee fell while moving a water canister, resulting in fractures to four fingers on her right hand.

An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.

An employee was mixing sauce using a sauce barrel mixer when his left little finger was amputated.

An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.

A temporary employee was carrying a nail gun through the warehouse when it hit his leg, activated, and fired a nail into the leg.