Struck by falling part of vehicle or machine, still attached · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Lozier Corporation, 6316 John J. Pershing Drive, OMAHA, NEBRASKA 68110
on — Fractures , affecting the Forearm(s).
Final narrative
An employee was repairing a hydraulic lift table and installed a locking chock on it. As he was working, the lift table collapsed, pushing the chock out and crushing his left arm. He sustained a fractured radius and ulna. The lift table was not locked out/tagged out at the time.
An employee's hand was on a spindle that controls flaps on a CNC saw machine. The flaps move up and down to guard and remove boards from the saw. The employee's left thumb was caught between the flaps, resulting in an amputation.
An employee was forming a part on a press brake. His left middle finger was pinched between the part being formed and the face/ram of the press brake, causing a partial amputation of the fingertip.
On July 3, 2018, a welder began to feel sick and went home. He was hospitalized the following morning to treat a heat-related illness that affected kidney function.
An employee was standing at the rear of a machine and the machine's mesh tray fell down onto the rear of the machine, crushing his left hand against the read lift. The employee sustained fractures and a laceration to their left hand and was hospitalized.
An employee had been tasked with hauling large rocks. There was a rock caught in the tailgate of the dump truck that was preventing it from opening. He went to get the rock out and the tailgate came down, crushing his right middle fingertip. The employee sustained a fracture of the distal phalanx and required surgery.
An employee was replacing the wear pan in a wood chipper when a metal sawdust pipe attached to the machine fell from above, pinning him against the machine. The employee suffered a broken right femur, right hip, and left hip.
Two employees were working on a forklift with its mast in the air when a chain came loose and the carriage fell down on them. The injured employee was hospitalized with a fractured left ankle, a laceration on the left side of their forehead, and a fractured L1 vertebra.
An employee was hooking up a hydraulic attachment on a forklift. When pressure was released from the hydraulic system's hose, the arm of the forklift came down on the employee's left foot and broke it.
More severe injuries in this industry (NAICS 337215)
On August 13, 2025, an employee was feeding wire through a junction box to feed a 120-volt circuit near a 480-volt bus duct. The bus duct suddenly combusted, and the employee suffered burns to his left hand and upper body. He was hospitalized.
An employee was operating a brake press and making the final bend on a steel part. Her right middle finger got caught between the part and the top punch as it bent the part upward. The employee sustained a crush injury resulting in amputation of the fingertip.
An employee was feeding scrap metal into a chipper when his right hand was squeezed against a metal component of the machine. He suffered an amputation to the right index finger at the second joint.
On June 18, 2025, an employee working as a millwork installer was cutting shims using a circular saw. The saw hit a knot in the wood and jumped, cutting the palm of the employee's left hand and causing partial amputations to three fingers. The employee was hospitalized.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.
An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.
An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.