Centerline Drilling, Inc.

An employee was operating a forklift on the airport ramp environment to help offload cargo pallets from a tractor trailer. He was manually locking the cargo dolly (a specialized piece of ground support equipment used to transfer pallets) to prevent the load device from shifting or falling off the dolly during transportation. The employee stepped between the K-loader and the dolly to put up a lock when they became pinned between the loader and the dolly, resulting in inflammation to their left leg. The employee was hospitalized.

An employee had been loading a trailer. Their foot was caught in the trailer and/or trailer hitch, resulting in a severe laceration to a toe that required surgical amputation.

An employee had been trimming trees. They were found unresponsive in the cabin of the trimmer. The employee suffered a concussion and was hospitalized.

The injured employee was standing on a form/bed where concrete is poured and was removing concrete from the form(s). Another employee indicated through hand signals to the injured employee that the chocks had not been removed from the strands. The employee jumped down from the bed to ground level. The bed then started moving toward him. He went to jump over the drive wheel to get out of the way of the bed, but his foot got caught in the drive wheel. The employee sustained a severe laceration and crush injuries to the foot that required surgery.

An employee was preparing meals in a kitchen when an object struck their head, resulting in a laceration to the head and a swollen right eye. The employee was hospitalized and required surgery for a brain injury.

An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.

A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.

An employee was working to remove a stuck fish tool from a drill shoe. Their thumb was struck by a hammer, resulting in amputation.

An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.

An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.

An employee was helping a coworker transport a tall palm tree with a mini skid steer. The employee was severely shocked by a high-voltage electrical wire above the ground.

An employee was retrieving a Christmas tree from a shelf using a ladder. He missed a step and fell to the concrete floor. He sustained injury to his head and wrist.

An employee was inspecting a generator whose radiator was leaking. He slipped, and a fan blade in the generator amputated his thumb and index finger.

An employee was operating an agricultural tractor during sugarcane harvesting. The employee sustained a lumbar sprain due to vibration or motion from the tractor.

An employee was moving a 3-ton condensing unit, strapped down on a dolly, out of a garage. The strap broke, causing the employee to fall backward onto the brick pavered driveway. The employee suffered injury to a spinal ligament in the neck.