Struck by other falling object n.e.c. · Amputations, avulsions, enucleations unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Kloeckner Metals Corporation, 7400 Mesa Dr., HOUSTON, TEXAS 77028
on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was placing 4x4 timbers under a steel plate that was being loaded onto a trailer for delivery. The plate was raised about 12 inches by four chains with hooks on the four corners of the plate. One side of the plate was flat and the other side was raised; the middle section was beveled upward. While the employee was placing the timber under the plate with his left hand, the plate lost tension and fell, crushing the tip of their left index finger. The employee's fingertip was amputated.
HospitalizedAmputation Finger or thumb tip(s), nail(s) Panels, sheets, plates metal
More severe injuries at Kloeckner Metals Corporation
An employee was transferring metal from a re-coiler to a turnstile. The employee's right middle finger was crushed between two coils of steel as he guided one of the coils off the processing line. He suffered an open displaced fracture to the finger.
An employee was using a hand-held pneumatic grinder to do a vertical grind of a metal gear rack when the griding disc flew off and hit the employee's left shoulder, resulting in a laceration that required hospitalization.
An employee was rigging steel beams for unloading from a trailer when he tripped and fell from the trailer to the ground, landing on his left side. He suffered a fractured left elbow, laceration, and contusions to the head.
An employee was moving the scrap skeleton of a steel plate when his thumb was caught between the scrap bin and the steel plate as it slid into place. His right thumb was fractured.
As an employee was stacking steel beams, a top beam rolled and pushed the other beams, which fell onto and crushed the employee's left ring finger. The fingertip was amputated.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.
An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.
An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.
An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.
On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.