LAC DU FLAMBEAU, WISCONSIN—
General Parts Group
Fall on same level due to slip or trip · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at General Parts Group, 510 Old Abe Road, LAC DU FLAMBEAU, WISCONSIN 54538 on — Fractures , affecting the Head and trunk.
Final narrative
An employee was walking out to a van with a leak detector tool in his hand. He slipped on ice on the walkway near the customer's docks and fell on the ground. He was also struck in the face by the leak detector unit. The employee sustained multiple skull fractures, and fractures to his pelvis and tailbone.
Similar incidents · Same event type
JERSEY CITY, NEW JERSEY—
JERSEY CITY MEDICAL CENTER
An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.
ELIZABETH, NEW JERSEY—
APM TERMINALS PORT ELIZABETH
An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.
VICKSBURG, MISSISSIPPI—
Hobby Lobby Stores, Inc.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
HALLETTSVILLE, TEXAS—
Regency IHS of Fairwinds Halletsville, LLC
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.
BERKELEY SPRINGS, WEST VIRGINIA—
Caperton Furniture Works, LLC
An employee tripped over a concrete curb stop in a parking lot. The employee fell to the ground, landing on their left hip and breaking it.
More severe injuries in this industry (NAICS 423830)
MIDLAND, TEXAS—
TRC Services of Texas INC
An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.
DEER PARK, TEXAS—
Onpoint Industrial Services Hiring Center
An employee was using a powered miter saw to cut 2x4's. The saw blade hit something inside a board (possibly a hidden nail) and jumped, causing a laceration to the employee's left forearm. The employee was hospitalized with soft tissue and tendon injuries that required surgery.
TULSA, OKLAHOMA—
S&R Compression, LLC
A crane had been used to set a steel plate on a steel frame. An employee was trying to remove a clamp from the plate when the plate fell and crushed the tip of his left little finger. The employee sustained a fingertip amputation.
GIRARD, OHIO—
Morgan Engineering Systems, Inc
An employee was operating a scissor lift, raised to a height of about 15 feet, to inspect an overhead crane rail. The crane itself was being moved. Its hook swung into the scissor lift s arms, causing the lift to tip over onto its side, which in turn caused the lift and the employee to fall to the floor. The employee suffered injuries including broken ribs, spinal fractures, scapula fractures, and internal injuries.
NORTH CHARLESTON, SOUTH CAROLINA—
Fairbanks Morse, LLC
A technician was operating a crane hoist to lift/remove a cylinder head from the main engine (port). The load was lifted at an angle, causing the cylinder head to get stuck on the cylinder head studs. When it became free from the studs, the cylinder head swung. It struck the technician and caught them against the cabinet door. This resulted in an amputation of their left index fingertip at the distal knuckle.
More severe injuries in WISCONSIN
MADISON, WISCONSIN—
RG Professional Carpenter, Inc.
The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.
FRANKLIN, WISCONSIN—
General Thermodynamics, Inc.
An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.
SAINT CLOUD, WISCONSIN—
Sargento Foods Inc
A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.
HIXTON, WISCONSIN—
Asher Enterprises, Inc.
An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.
VERONA, WISCONSIN—
Consolidated Electrical Distributors Inc.
An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.