DENVER, COLORADO—
Flawless Steel Welding LLC.
Struck by suspended or swinging objects n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury at Flawless Steel Welding LLC., 5353 Joliet Street, DENVER, COLORADO 80239 on — Fractures , affecting the Leg(s) unspecified.
Watch Flawless Steel Welding LLC. — free
Get an email when a new federal OSHA severe-injury report for Flawless Steel Welding LLC. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was moving a 20-foot-long steel beam using an overhead crane. After lowering the beam onto dunnage wood, the employee unhooked it and began to move the crane. The crane's lifting attachment, which had not been fully removed, lifted the beam and caused it to roll toward a nearby pile of steel. The beam pushed the employee into the pile of steel and he suffered a broken leg.
More severe injuries at Flawless Steel Welding LLC.
DENVER, COLORADO—
Flawless Steel Welding LLC.
An employee was walking into the workplace and slipped and fell on ice, resulting in a broken hip.
View Flawless Steel Welding LLC.'s full OSHA safety record →
Similar incidents · Same event type
POCONO SUMMIT, PENNSYLVANIA—
Ardent Mills
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
NEBRASKA CITY, NEBRASKA—
Concrete Industries Nebraska City
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
AUGUSTA, MAINE—
Cives Steel Company New England
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
NORTHPORT, ALABAMA—
Hanna Steel Corporation
An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.
GRAND BAY, ALABAMA—
Tri-State Tree Service LLC
Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.
More severe injuries in this industry (NAICS 238120)
COLUMBUS, OHIO—
Foundation Steel, LLC
An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.
ATHENS, TEXAS—
Red Dot Corporation
An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.
JAMAICA, NEW YORK—
Cornell & Company, Inc.
An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.
AUSTIN, TEXAS—
K Constructor, LLC
An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.
KINGS MOUNTAIN, NORTH CAROLINA—
Bowman Steel, LLC
An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.
More severe injuries in COLORADO
GREELEY, COLORADO—
ABC Supply Company
An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.
BOULDER, COLORADO—
Burke Builders Inc
An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.
LONGMONT, COLORADO—
Circle Graphics, Inc.
An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.
DENVER, COLORADO—
FLATIRON CONSTRUCTION CORP.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
BURLINGTON, COLORADO—
Takkion OPS Management
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.