Federal OSHA recorded a severe workplace injury
at Heartstone Inc, 300 N McLean Blvd Wichita KS 67203, WICHITA, KANSAS 67203
on — Amputations, avulsions, enucleations unspecified, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee was at the jobsite preparing to help with the use of a new rock clamp that is operated by machine but guided into place by hand on the ground. The employee reached and gripped the bottom of the clamp to move it. Linkage activated that crushed his left middle fingertip resulting in an amputation.
HospitalizedAmputation Finger or thumb tip(s), nail(s) Clamps, couplings
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.
An employee was installing a hydraulic extension cylinder in a tow truck when their leg was caught between the cylinder and the truck frame. The employee was hospitalized with a broken tibia, which required surgery.
An employee was sorting sucker rods. His right hand was caught in the area where the rod hits up against the frame and his index fingertip was amputated just below the nail.
More severe injuries in this industry (NAICS 321999)
An employee was using a telehandler to move pallets of pellets from a pod. The employee exited the telehandler to pick up a sacrificial pallet that is placed under the bottom layer of pallets. When the employee turned to pull the pallet away, the top two tiers of the pod fell on him. The employee sustained a fractured ankle, three fractured ribs, and fractured vertebrae.
An employee was preparing to replace a belt on a fan drive assembly. He went to manually stop the fan and was caught by the belt. His hand was pulled into the machine and his left little fingertip was amputated.
An employee was cutting remanufactured lumber with a chainsaw when a board fell and struck his left hand, causing his left hand to move off the chainsaw. While he was moving his hand back, the chainsaw kicked back and lacerated the top of his left hand. The employee was hospitalized.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.