Struck by suspended or swinging objects n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Concrete Pipe & Precast, LLC, 405 Corning way, MARTINSBURG, WEST VIRGINIA 25405
on — Fractures , affecting the Rib(s), oblique area.
Final narrative
An employee was moving a 4x4 box jacket with an overhead crane. The employee hooked a chain to the jacket and put tension on it. It spun awkwardly, striking the employee and knocking him over. The employee fell on the same level and sustained a fractured rib and lacerations to his lower left abdomen and backside.
Hospitalized Rib(s), oblique area Structural elements n.e.c.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.
Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.
More severe injuries in this industry (NAICS 327332)
An employee was anchored to a movable piece of equipment called a "lid" with a self-retracting lifeline harness. An overhead crane lifted the equipment, causing the employee to be pulled by his harness. The employee was pulled off the walkway and swung over the wall of the kiln. His body and head struck the wall. The employee lost consciousness and sustained a laceration to the side of his head that required stitches. The employee also sustained multiple fractured ribs and fractured vertebrae.
An employee was using an overhead crane to lower a manhole cylinder to the ground to complete maintenance and cleaning. While removing a lifting hood from a manhole core (steel cylinder), the cylinder rolled and the employee's left little finger was caught between the crane hook and the lifting eye. The employee's little fingertip was amputated just below the nail.
An employee was guiding a forklift operator who was placing a 48-inch form jacket (open cylinder) over a core (solid, stationary cylinder). The employee was positioned on the ground adjacent to the core. As the suspended jacket was positioned over the core, a gust of wind caused the jacket to move. The employee reached to steady it and the jacket moved downward pinching his left little finger between the jacket and the core and resulting in a fingertip amputation.
An employee was at the bell packer when the scraper of the bell packer struck his hand. The employee sustained broken fingers and degloving injuries involving their right ring and little fingers.
An employee was cleaning out a mixer lid when a hatch fell from its open position and severed the tip of his left thumb. The employee sustained a partial amputation of the tip of their left thumb.
An employee was conducting routine maintenance on a mixer. New lid pins had been installed, and the employee was rotating by hand to ensure they had been installed correctly. The employee's left middle finger was caught between the lid and top of a pin. The momentum from the mixer continued, causing a crushing injury to the finger. The employee underwent a medical amputation from the top knuckle to the tip of the finger.
An employee was climbing down a 15-foot multipurpose ladder. The employee fell about 8 feet, landing on the concrete floor and the ladder itself. The employee suffered several injuries, all on the right side: broken ribs, a broken sternum, a broken temporal bone, broken shoulder, multiple fractures to the cheekbone, and a brain bleed.
An employee was rolling up the landing gear on his trailer when the handle began to unwind and struck his face, fracturing his jaw. The employee was hospitalized and required surgery.