Struck by suspended or swinging objects n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Beasley Forest Products, Inc., 712 Uvalda Highway, HAZLEHURST, GEORGIA 31539
on — Fractures , affecting the Leg(s) unspecified.
Final narrative
A drive chain broke at the wave feeder on the log line infeed. The injured employee came to help move logs with a remote-controlled hoist so they could reach the chain sprocket. He connected the log grapple to a log and started to lift the log with the hoist. The log rolled and pinned his left leg against another log, fracturing his leg. The employee was hospitalized.
Hospitalized Leg(s) unspecified Logs
More severe injuries at Beasley Forest Products, Inc.
An employee was walking to a break area when she was struck and run over by an industrial forklift. The employee was hospitalized with an injury to her body and a severe leg injury.
An employee was replacing nylon guides inside the dry sorter bay. He was holding onto the hoist cable for support as he entered the sorter bay when the lumber racks in the bay slowly went down, causing his left hand and fingers to become caught between the hoist cable and pulley. The employee sustained fractures to his middle, ring, and little fingers and an amputation to the ring fingertip.
An employee's right hand was caught in a chain after a machine started up while he was looking at a jammed log. The employee suffered multiple finger amputations on his right hand and was hospitalized.
An employee was clearing a jam in a conveyor system of the dry sorter area. Clearing the jam jarred the board, causing the employee to fall approximately 20 feet to the floor. They sustained a lower left leg fracture.
An employee was working on the wheels of a hydraulic lift table. When he disconnected the hydraulic hose to relieve pressure, the scissors and weight from the back half of the table fell onto his right arm. The arm, elbow, and hand were crushed.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.
Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.
More severe injuries in this industry (NAICS 321113)
An employee was repairing a photo eye on the infeed roll case when they dropped a tool. The employee went to grab the tool and his fingers contacted the chain and sprocket of the infeed roll case. His fingers were pulled into the pinch point and the fingertips were crushed, resulting in amputation of one fingertip.
An employee was troubleshooting dispersing equipment. A belt and pulley system was energized, and the moving belt caught the employee's right ring finger. He suffered a partial amputation at the first knuckle, below the nail.
An employee was cleaning the photo eye sensors of a piece of equipment between the saw that cuts lumber into lengths and boards. The employee stepped on a metal grate that gave way and fell 8-10 feet. The employee was able to remove himself from the conveyor. His tibia was fractured just below the knee.
While refilling a lubricant tank, an employee observed that a pump was not operating correctly. While troubleshooting the issue, the employee reached toward the back of the pump to check for proper airflow. Their left index finger contacted moving components in the pump's piston mechanism, resulting in partial amputation of the fingertip.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.