Struck by propelled, falling, or suspended object unspecified · Nonfatal 'crushing' injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Mai Oil Operations, Inc., North of Intersection of R Road and 360 Ave, in the SW/4 sec 29-13-21W, ELLIS, KANSAS 67637
on — Nonfatal 'crushing' injuries, affecting the Neck and back.
Watch Mai Oil Operations, Inc. — freeGet an email when a new federal OSHA severe-injury report for Mai Oil Operations, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee was preparing to install a wrist pin that was suspended by a winch truck into a pumping unit when the winch truck pole fell, striking them. The employee sustained a head laceration and crushing injuries to the cervical and thoracic regions of their spine.
Hospitalized Neck and back Vehicle and mobile equipment parts n.e.c.
An employee was activating the sprinkler system at a sports complex following recent maintenance to repair leaky pumps. When the system was activated, a section of newly installed 3-inch schedule 80 PVC pipe struck the employee, who lost consciousness. The employee suffered a broken jaw and a concussion.
An employee was cutting metal with a torch. A piece of metal struck the employee's left foot, causing multiple fractures to metatarsal(s). The employee was hospitalized.
An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.
An employee was repositioning a large casting with a chain. The chain slipped and landed on his hand, resulting in hospitalization with a fracture to his upper arm and a crushing injury to his thumb.
An employee was installing a rear suspension airbag beneath a hydro-excavation truck when the airbag slipped off the truck's frame and struck him in the face. The employee sustained multiple facial fractures and an intraparenchymal hemorrhage and was hospitalized.
More severe injuries in this industry (NAICS 213111)
An employee was stepping down off a 6-inch containment platform to finish loading his truck, when his right ankle rolled. The employee sustained a fractured tibia and fibula at the right ankle and required surgery.
A service crew was pulling a pump and motor from a well. After breaking a joint of pipe loose from another joint, an employee grabbed the chain tongs to prevent the pipe from spinning in the well, so the crew could continue taking it apart. The bolt that attaches the chain to the handle of the chain tongs broke, causing the chain to swing around and strike the employee's lower right leg. The chain severely punctured his leg and fractured his tibia.
An employee arrived on location and loaded a blow-out-preventer (BOP) on a 1-ton flatbed truck. While standing on the flatbed securing the the BOP, the employee stepped into a void/hole on the flatbed surface. This caused him to lose balance and fall off the truck bed with his leg still caught in the hole. As a result, he sustained fractures to his left leg.
An employee was rigging up a location. He was using an Allen wrench to free up rotation and start the drawworks engine manually. The engine rotated and his left little finger became caught between the Allen wrench and the engine. The employee sustained an amputation to his little finger and fractures to his wrist.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.