Phoenix Metals- Kansas City

An employee was painting a round module when a front-end loader ran over his right leg and crushed it.

An employee was operating a switch truck at a rail yard. He got out of the switch truck to unlock a container that was attached to a unit in front of him. The switch truck rolled and pinned the employee against the container. The employee sustained a fractured pelvis, a ruptured spleen, and a possible spinal cord injury.

On October 16, 2025, an employee was entering a parking lot after completing their work shift when they were struck by a vehicle being operated by a customer. The employee fell backward from the impact and the back of their head struck the asphalt. The employee was hospitalized due to brain bleed and a skull fracture.

An employee was moving branches and other material when they were struck in the leg by the track of a skid-steer loader, resulting in an ankle and lower leg injury.

An employee was waiting for an operator to bring mail over to a mail sorting machine when she became pinned between the machine and a stack of pallets being pushed by a powered industrial truck (PIT). The employee suffered bruising and swelling on her hips, lower back, knees, and left side; a puncture wound to her left thigh from a machine screw; a crushed right hand with numbness and tingling; numbness to the left big toe; and a right wrist sprain.

A load of steel angles was being lowered when the lifting chain hit the load, causing it to slide toward an employee. An angle slid and pinched the employee, catching both of their legs between the beams and an angle. The employee suffered two fractured legs.

An employee was on the deck of a trailer helping a customer unload tubes. The employee was working to place a cargo strap on the remaining tubes using a winch bar when it slipped off the tubing, causing him to lose his balance and fall headfirst onto the asphalt lot below. The employee suffered a contusion on his forehead, resulting in hospitalization.

An employee and a customer were unloading two rectangular tubes. The tubes were wrapped together. The plastic wrap was cut so that one tube could be picked up. As the employee was lifting the top tube, the other tube (still connected to the top tube) came down onto his hand and broke two of his fingers. He was hospitalized.

An employee was assisting as a forklift got pipe from a pipe rack. The employee was on one of the forklift's forks as it was raised to the top of the rack, a height of about 15 feet. He fell to the ground and suffered a dislocated and fractured right elbow.

On September 23, 2025, at approximately 7:43 p.m., an employee was using a knife to cut poly banding from a metal coil. The knife slipped, causing a laceration to the inside of their left arm at the elbow joint. The employee was hospitalized and required surgery to repair a damaged vein.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.