Ignition of clothing from controlled heat source · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at KENNEDY VALVE, A DIVISION OF MCWANE, INC, 1021 E. WATER STREET, ELMIRA, NEW YORK 14901
on — Heat (thermal) burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
Employee leaned against break room space heater. His clothing caught fire and while attempting to disrobe, he burned his hands and back. Employee was hospitalized overnight.
HospitalizedMultiple body parts, n.e.c.Furnaces, heaters
More severe injuries at KENNEDY VALVE, A DIVISION OF MCWANE, INC
An employee was welding metal parts. The employee turned to the left and their work uniform came in contact with the location on the part that had just been welded. The employee's uniform ignited, causing burns to their shoulder and back.
An employee was welding steel dump ramp slides. He leaned over and a previous weld caught his hoodie on fire. The employee sustained burns on his left side from the armpit to the waistline.
An employee was using a fiber wheel to cut a 55-gallon drum to make a trash can. As they were cutting, sparks flew into the barrel and fire came out of a hole on the barrel, catching the employee's shirt on fire. The employee sustained burns to their abdomen and chest, requiring hospitalization.
An employee was removing tubing caps and cleaning tubing ends with solvent. Their flame-resistant pants became soaked with the cleaning solvent and were ignited by a propane torch used for removing tubing caps. The employee was hospitalized with burns to their legs.
More severe injuries in this industry (NAICS 332911)
An employee was repositioning a large casting with a chain. The chain slipped and landed on his hand, resulting in hospitalization with a fracture to his upper arm and a crushing injury to his thumb.
An employee was performing a machine set-up and had installed one set of holding jaws. His right index finger became caught in an air vise while re-clamping a part. The employee sustained a partial amputation above the fingernail.
Two employees were re-packing a butterfly valve. The valve was being held by a crane. An employee added air to the valve to close it. The valve moved and the other employee reached to steady it. His thumb was caught in the valve and the thumb tip was amputated.
An employee was preparing to install a production tree/master valve. The employee grabbed the bull plug and shook the production tree into place. The well blew out on the casing side. The pressure caused the production tree to fall over onto the employee, resulting in a fractured right leg.
An employee was manually moving a 30-pound valve. When he sat the valve down, it crushed his left index fingertip just above the nail and amputated it.
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.
An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.