ATT

An employee was climbing a pole. The employee fell off the pole, landing on the ground and suffering a broken leg. The incident occurred during a training activity.

An employee was working on an extension ladder, installing or repairing wiring, and fell to the ground sustaining a broken right leg.

An employee was lifting a cable off the floor when he felt pain in his abdomen. The employee was hospitalized.

An employee was working at a residential home. While ascending a ladder outside, the employee fell around 9 feet to the ground, requiring hospitalization for a possible rib injury and a collapsed lung.

An employee was working on a generator with a grinder, cutting off the end of the exhaust pipe, when the grinder flew back and hit the right side of his face. He sustained a cut.

An employee was using a shepherd's hook to help position a jib crane. The hook slipped and the employee fell into an adjacent structure, suffering three broken ribs and a punctured lung.

An employee was taking measurements of a parapet cap when they fell to the ground sustaining fractures to a shoulder and arm.

An employee was cleaning a two-story house. They fell approximately 12 feet from the roof to the floor and sustained fractures to both wrists.

An employee was using a water hose to clean the outside of a wastewater drain system when he fell into an area of the drain that was not covered. Hot water and chemicals caused first, second, and third-degree burns all over the employee's body. The employee was hospitalized.

An employee was cutting down a steel above-ground storage tank. He was on the roof of the tank when he fell 20 feet to the ground, resulting in a broken elbow and sprained leg. The employee was wearing a harness that was tied off at the time.

A mechanic was replacing the airbag suspension on the front axle of a utility trailer. The airbag blew out, causing an injury to the mechanic's left foot that required hospitalization and surgery.

Employees were installing a truck scale and lowering a module when the injured employee's right ring finger was caught between the module and a side rail. The employee sustained an amputation of the finger to the first knuckle.

An employee was using a 40-ton press to remold a steel part when a steel plug guide shot out from the press and struck the employee in their midsection, causing three broken ribs and a hematoma.

An employee was servicing an air handler at ground level when their left hand contacted a rotating belt. The employee sustained a fingertip amputation.

An employee was calibrating a 100-ton transfer rail using a forklift attachment referred to as an evener which was a metal lifting device. The employee was holding the evener up so that another employee could slide the forklift tines under the evener bar and lift the calibration blocks. During this process one of the forklift tines pinched the employee s right ring finger between the tine and the evener bar resulting in a fingertip amputation.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.